Overview
The Moog front camber bolt kit K80087 is a front suspension kit that fits 2004 to 2008 Ford F-150 and Lincoln models. A camber bolt adjusts the wheel’s inward or outward tilt at its mounting point and is set during a wheel alignment. The kit is sold individually.
The kit has a powdered metal gusher bearing that routes grease through the bearing to the stud, a patented cover plate designed for tighter tolerances, and a full ball metal stud with 360 degrees of rotation. The design uses patent pending Sunoloy coated bearings.
Key features
- Front camber bolt kit
- Powdered metal gusher bearing design.
- Patented cover plate design.
- Full ball metal stud, which MOOG says rotates through 360 degrees
- Sold individually
Front camber and replacement timing
A front camber bolt sits where the upper control arm or strut mounts to the frame, so it sets the top of the wheel’s inward or outward tilt. On a truck like the F-150, camber drift often shows up as uneven tire wear on one edge. Because the bolt is adjusted during an alignment, it is usually replaced only when the setting cannot be held or the bolt shows wear.
Replacing one side of a front camber pair can leave the two sides with different settings, so inspect both sides when one needs work. Check the mounting holes for elongation or rust, and make sure the bolt threads and bushing sit squarely before the alignment is done.
- Look for uneven tire wear on the outer or inner edge
- Check for play at the bolt and nearby ball joints
- Confirm the front alignment after replacement
Specifications
| Brand | Moog |
|---|---|
| Part number | K80087 |
| UPC | 80066321295 |
| Product type | Front camber bolt kit |
| Axle position | Front |
| Sold as | Individually |
Vehicle fitment
The listed fitment covers 2004 to 2008 Ford F-150 models and 2004 to 2008 Lincoln Navigator models, along with 2004 to 2005 Lincoln Aviator, 2006 to 2008 Lincoln Mark LT, and 2007 to 2008 Lincoln MKX and Navigator L models. The list does not include other F-150 generations, so a 2009 or newer F-150 is not covered by these entries. Match your model and year to a listed entry before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because a camber bolt changes wheel angle, the front end should be aligned after the kit is installed. The bolts are typically set during that alignment, so a shop with alignment equipment is the practical choice.
What’s included
One front camber bolt kit, sold individually, part number K80087.
Not included: Check the hardware in the kit against your installation before starting.







