Overview
This 16 in travel version of the Bilstein 8125 Series coilover with reservoir, part number 33-225654, is a 60mm threaded-body coilover shock for custom off-road builds. It is intended for universal off-road use rather than one named vehicle, and the springs are sold separately.
The 8125 line is built around dual-rate springs, and this model’s 26.5 in collapsed length stretches to 42.5 in extended, giving 16 in of travel. A remote reservoir linked by a high-temperature hose is meant to keep damping consistent when the shock heats up. Owners can rebuild the unit with Bilstein replacement parts, and the zinc-coated threaded body allows quick height changes.
Key features
- Reservoir and high-temperature hose for steady performance in intense heat
- Competition-designed, 3-stage seal pack
- 22mm hard chromed, case hardened piston rod
- Rod is resistant to sand blasting and rock chipping
- Threaded body for ride height and spring changes
- Eye mounts at both ends
- Rebuildable by owners with Bilstein parts
- Machined to precise tolerances in the USA
Coilover setup basics
A coilover combines the shock and spring in one assembly, and the threaded body lets you set ride height by turning the spring perch. Changing height changes spring preload and geometry, so adjust in small steps and recheck the alignment, steering geometry and clearance to the tires after each change.
A remote reservoir gives the damper more oil volume, which helps when the shock heats up on long runs or repeated climbs. Route the hose so it stays clear of heat sources, moving parts and the tire. Inspect the seals and rod surface regularly, since dirt on the shaft can quickly damage the seal.
- Set ride height before final spring adjustments
- Recheck clearances after every height change
- Keep the rod clean and inspect seals after each trip
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-225654 |
| UPC | 651860754789 |
| Series | 8125 Series |
| Shock type | Hydraulic / gas charged, coil-over |
| Body design | 60mm ID threaded body, screw top (coilover) |
| Reservoir | Yes, remote |
| Standard body size | 16 in |
| Travel length | 16.00 in |
| Collapsed length | 26.5 in |
| Extended length | 42.5 in |
| Lower mount | Eye |
| Upper mount | Eye |
| Shaft diameter | 22mm |
| Finish | Zinc plated |
| Compression | 1100 |
| Rebound | 3700 |
| Springs | Sold separately |
Vehicle fitment
Bilstein’s 33-225654 is a universal off-road listing, so it is not tied to a particular model year or chassis. Fit depends on the 26.5 in collapsed length, the 42.5 in extended length and your mounting points, so take measurements before buying springs.
With no vehicle named, this coilover does not cover any specific model by default; match its dimensions to your build. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Springs are not included, so pick dual-rate springs that suit this 26.5 in collapsed and 42.5 in extended length and your target ride height. Route the remote reservoir hose away from moving parts, and support the vehicle on stands while you adjust the body.
What’s included
The 8125 Series coilover with its remote reservoir and high-temperature hose.
Not included: Springs, which are sold separately.









