Overview
The Bilstein 8100 Series 25-293319 is a rear left piggyback reservoir shock for the 2018–2026 Jeep Wrangler (JL). It is a 60mm large bore unit for lifted trucks and SUVs, with eyelet mounts at both ends.
The body is built from aerospace quality billet components. A 60mm inside diameter provides a higher oil volume, which helps control heat when the truck runs over rough road surfaces for long distances. The monotube design uses velocity sensitive digressive valving, and the large piston is intended to add comfort and control.
This is the piggyback type, not a remote reservoir shock, and it fits the rear left position. The reservoir sits alongside the body and needs room at the rear. Most Wranglers have limited space there, so check how far the piggyback reservoir extends beyond the body before mounting. The unit is one rear left shock.
Key features
- Rear left position
- Piggyback reservoir arrangement
- 60mm large bore billet body
- Monotube design with velocity sensitive digressive valving
- Eyelet top and bottom mounts
Rear clearance planning
The rear of a Wrangler has less room than the front, so a piggyback reservoir needs careful planning. Look at where the reservoir body will sit relative to the wheel well, the spare tire, the fuel tank area and the rear brake lines. Clearance at full compression is the one most often missed, since the reservoir can contact a bracket or the frame as the axle moves up. Route any hose or reservoir mounting so it cannot rub on sharp edges.
Piggyback reservoirs also change how a shock is handled during installation. The body and reservoir are heavier to lift into place, and the reservoir clamp must be snug before the lower mount is tightened. Replacing both rear shocks at the same time keeps damping even from side to side, and a bump stop or spring that looks worn is worth inspecting while the shock is out.
- Check reservoir clearance at full compression before tightening
- Keep hoses away from brake lines and sharp edges
- Inspect bump stops while the shock is removed
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 25-293319 |
| Shock series | 8100 Series |
| Position | Rear left |
| Shock type | Piggyback reservoir |
| Body diameter | 60mm |
| Top mount | Eyelet |
| Bottom mount | Eyelet |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2018 through 2026 Jeep Wrangler (JL), in both two-door and four-door body styles.
Wranglers from before 2018, Gladiator models and the rear right position are not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear left piggyback reservoir shock absorber.
Installation notes
Check the clearance for the piggyback reservoir at the rear before mounting, and confirm you have the left side for this position.










