Overview
The Bilstein 5100 Series shock absorber, part number 24-185950, is a front-position, gas-charged monotube damper with a clevis lower mount and a stem upper mount. It is designed for trucks with a 4 – 6 in. lift and keeps the original equipment mounting points. Its 46mm inside-diameter smooth body is non-coilover.
The 5100 Series is a traditional single-tube design under high gas pressure, built for consistent, fade-free performance over a long service life. At 14.15 in collapsed and 21.38 in extended, it provides 7.23 in of travel. The shaft is 14mm and the finish is zinc plated. The high-flow piston and independent tuning help keep damping controlled on large-diameter tires.
Key features
- Monotube gas pressure construction.
- Self-adjusting deflecting disc valving.
- High-flow piston that Bilstein says reduces harshness.
- Independent rebound and compression tuning.
- Larger working piston area for exact damping.
- Designed for manufacturer lift kits that keep the stock mounting configuration.
- Boot included.
Clevis mounts and alignment
A clevis lower mount uses a pin and a bracket with a fixed angle, so the pin size and bracket clearance must match before fitting. Measure both the lower clevis and the upper stem before ordering. Lift changes can shift how the shock lines up with the axle, which is why the mounts are worth checking early.
A lift in the 4 – 6 in. range usually changes driveline and alignment angles, so plan for an alignment check once the new shock is installed. Inspect the boot and mount bushings after the first few drives, and re-torque fasteners after the first trail runs. Gas-charged units are pressurized, so have them serviced by a qualified shop.
- Confirm clevis pin size
- Check driveline angles after lift changes
- Inspect boot and bushings after first drives
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-185950 |
| UPC | 651860482026 |
| Shock series | 5100 Series |
| Position | Front |
| Fitment | Direct Fit |
| Lift height | w/4 – 6 in. Lift |
| Collapsed length | 14.15 in |
| Extended length | 21.38 in |
| Travel length | 7.23 in |
| Lower mount | Clevis |
| Upper mount | Stem |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Reservoir | No |
| Finish | Zinc Plated |
| Boot included | Yes |
| Hydraulic / gas charged | Gas charged |
Vehicle fitment
Vehicle fit is not confirmed for a specific year, model or chassis. The unit is a front position shock for a 4 – 6 in. lift with Direct Fit mounting. Confirm your vehicle’s year, model and trim before ordering.
Measure the clevis lower mount and stem upper mount against your current front shock, and check the lift height, before choosing this part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The clevis lower mount needs the correct pin size for your lower bracket. A lift kit in the 4 – 6 in. range usually calls for alignment and driveline angle checks once the new shock is installed.
What’s included
One 5100 Series front shock absorber with a boot.
Not included: mounting hardware, to be checked against your installation.









