Overview
The Bilstein 24-185639 is a 5100 Series gas-pressure monotube shock absorber with a 16mm eye at the bottom and a bar pin at the top. Its collapsed length is 13.68 in and its extended length is 21.85 in. No vehicle years, makes or models are published for this part.
The 5100 Series uses traditional single-tube technology built for consistent, fade-free performance and long life. It is designed for lifted trucks, Jeeps and prerunners, with self-adjusting valving, a high-flow piston and independent rebound and compression tuning. It is designed for certain lift kits that keep the stock OEM mounting layout.
Key features
- Single-tube gas-pressure monotube construction
- Self-adjusting deflecting disc valving
- High-flow piston for reduced harshness
- Independent rebound and compression tuning
- Boot included with zinc plated finish
Measuring before you buy
Length and mount type decide whether a shock can be installed at all. Measure the collapsed and extended lengths of your current unit, then compare them with the replacement. Note whether the lower and upper ends are eyes, bar pins or studs, because a length match alone does not guarantee a bolt-up fit.
A gas-pressure monotube holds its charge under pressure, so it should never be opened or heated. Keep the body intact during removal and store the old unit upright until it is disposed of properly. Inspect the boot for splits, since debris can scratch the shaft and wear the seal.
- Measure collapsed and extended length on the current unit
- Note whether each end is an eye, bar pin or stem
- Compare the boot condition before reuse
- Plan for any bushings or hardware not in the box
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-185639 |
| UPC | 651860608402 |
| Shock series | 5100 Series |
| Design | Monotube, gas charged |
| Collapsed length | 13.68 in |
| Extended length | 21.85 in |
| Travel length | 8.17 in |
| Lower mount | Eye 16mm |
| Upper mount | Bar pin |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Finish | Zinc plated |
| Reservoir | No |
| Boot included | Yes |
Vehicle fitment
No vehicle years, makes or models are confirmed for this part. Match the mount and length dimensions to your application before buying.
Compare the 13.68 in collapsed and 21.85 in extended lengths with your current shock. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The eye-and-bar-pin mount combination is specific, so confirm that your existing brackets accept it before buying. Monotube gas-pressure shocks hold a charge, so keep the body intact and do not open or heat it.
What’s included
One Bilstein 5100 Series shock absorber with boot included.
Not included: Mounting hardware and bushings are not included.









