Overview
The Bilstein 5100 Series front shock absorber, part number 24-066464, is a mono tube, gas-charged shock with an eye lower mount and a stem upper mount. Bilstein positions the 5100 Series for lifted trucks, Jeeps and prerunners that run large-diameter tires.
This shock has a 46mm smooth, non-coilover body, a 14mm shaft and no reservoir. It carries a w/4 – 5 in. lift rating and is built for specific lift kits that keep the factory O.E.M. mounting configuration. Compare the mounts with your kit before installation.
Key features
- Monotube gas pressure construction in a single-tube body.
- Self-adjusting deflecting disc valving.
- High-flow piston that Bilstein says reduces harshness.
- Independent rebound and compression tuning.
- Larger working piston area for damping control with large-diameter tires.
- Boot included.
Lift kits and mounts
A shock for a lifted truck or Jeep has to match two things: the suspension height and the mounting points on the frame and axle. Large-diameter tires increase the load on the shock body, which is why a larger working piston area and a 46mm body are useful on these setups. Because the shock is gas charged, it should never be opened or heated during installation.
Before choosing a shock for a lift kit, measure the collapsed and extended lengths against the shock you are replacing and against the new ride height. Check that the eye and stem mounts will clear brake lines, sway bar links and the axle at full extension. Bump stops and shock tower bushings often need attention when a suspension is raised.
- Measure both lengths before ordering
- Check clearance at full extension
- Inspect bump stops and bushings
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-066464 |
| UPC | 651860639888 |
| Series | 5100 Series |
| Position | Front |
| Collapsed length | 16.34 in. |
| Extended length | 27.32 in. |
| Travel length | 10.98 in. |
| Lower mount | Eye, 14.12mm |
| Upper mount | Stem |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Reservoir | No |
| Gas charged | Yes |
| Finish | Zinc plated |
| Boot | Included |
| Fitment type | Direct fit |
| Lift height | w/4 – 5 in. lift |
Vehicle fitment
Fit is not confirmed for any vehicle with this part number. Confirm fit for your vehicle’s year, model and trim before ordering, and check the shock length and mount type against your truck or lift kit.
Compare the 16.34 in. collapsed and 27.32 in. extended lengths with the shock you are replacing. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 14.12mm eye lower mount and stem upper mount must match the brackets on your vehicle or lift kit at both ends. Do not assume a bracket fits just because it fits a similar truck or Jeep. Because the body is gas charged, avoid cutting it open or applying heat.
What’s included
One Bilstein 5100 Series shock absorber with a boot.
Not included: mounting brackets, hardware and lift kit parts are not part of this part number.









