Overview
The Bilstein 5100 Series 24-285063 is a rear shock absorber for the 2014–2024 Ford Expedition, the 2014–2017 Expedition EL, the 2018–2024 Expedition Max and the 2014–2019 Lincoln Navigator models. It is a ride height adjustable unit with a rear lift of 0 to 1.5 inches, and it is meant for vehicles without a load leveling suspension.
The shock uses a zinc-plated, snap-ring grooved body. The spring seat can be set in different grooves, and that position determines how much the rear rides up. The unit is a monotube design with a digressive piston and a self-adjusting deflective disc valve. Its collapsed length is 15.00 inches, its extended length is 20.95 inches and its travel is 5.95 inches.
Because the shock is a rear unit, it pairs with the front unit used on the same vehicle when the whole truck is being lifted. Measure the existing rear shock before ordering to confirm the fit, since the extended length is the figure that matters most for the mounting.
Key features
- Rear lift height of 0 to 1.5 in
- Snap-ring grooved 46mm body with a zinc-plated finish
- Monotube design with a digressive piston
- Travel of 5.95 in
- Designed for vehicles without load leveling suspension
Rear load and lift balance
A rear shock controls how the rear axle moves over bumps, and it works with the springs and bump stops to carry the vehicle’s weight. Raising the rear changes how the axle sits under load, so the shock needs to match the rest of the rear suspension. Look at the bump stops, springs and rear mounts, since these are often replaced at the same time as the shock.
Because lift changes ride height, check the driveshaft angle and brake lines after the rear is set. A shock that extends too far can strain these parts, so compare the new unit with the old one before the truck goes back on the road.
- Inspect bump stops for cracking
- Check driveshaft angle after the rear is raised
- Compare the old and new shock at both mounts before installing
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-285063 |
| Shock series | 5100 Series (ride height adjustable) |
| Position | Rear |
| Body diameter | 46mm |
| Rear lift height | 0 to 1.5 in |
| Collapsed length | 15.00 in |
| Extended length | 20.95 in |
| Travel | 5.95 in |
| Reservoir | No |
| Load leveling | Not compatible |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2014 through 2024 Ford Expedition, the 2014 through 2017 Expedition EL and the 2018 through 2024 Expedition Max. It also fits the 2014 and 2015 Lincoln Navigator, the 2017 through 2019 Navigator and the Navigator L in those same years.
The Expedition models outside these years, and Lincoln Navigator models from 2016, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Part 24-285063: one rear shock absorber, sold individually.
Installation notes
This rear unit is for vehicles without load leveling suspension, so confirm that before fitting. Check the rear ride height after the new shock is installed, and keep the front lift in step with the rear.









