Overview
The Baja Designs S8 50 inch Roof Light Bar Kit with Toggle Switch Harness, part number 447758, is an LED light bar kit for the 2021–2026 Ford Bronco. The 50 inch S8 light bar is rated at 300 watts with 31750 lumens, and it carries IP69K waterproof and IK10 impact ratings.
The kit includes the 50 inch S8 light bar, vehicle specific mounting brackets, hardware and a toggle switch wiring harness. Baja Designs says no cutting, trimming or drilling is required, and that the wiring is pre-sized for the vehicle. The light bar is built with a billet machined aluminum bezel and a hard coated polycarbonate lens.
The kit suits off-road and outdoor use and adds light for night driving. The amp draw is 20 and the LED life expectancy is 49,930 hours.
IP69K means the light is dust tight and resists close-range, high pressure, high temperature water spray. IK10 is a high level of impact resistance. Both ratings apply to this bar.
Key features
- 50 inch S8 LED light bar
- 300 watts and 31750 lumens
- Toggle switch wiring harness with pre-sized wiring
- Vehicle specific mounting brackets and hardware
- IP69K waterproof, submersible to 9 ft
- IK10 compliant and exceeds MIL-STD810G testing
Wiring and fused power
A roof light bar draws enough current that the power source should be protected. A fuse close to the battery or the power point guards the wiring if a short occurs, and a relay lets the switch carry only a small current while the light bar receives full power through the relay.
Follow the wiring layout in your kit and route the harness away from moving parts, exhaust heat and sharp edges. Keep the switch in a spot that is easy to reach while driving. Before wiring, check that the circuit has spare capacity for the load you plan to run alongside the light bar.
Roof lights see vibration and weather, so inspect the bezel seal, bracket bolts and connector housings after rough trail use. Retighten fasteners that have loosened and replace any seal that is cracked or flattened.
Specifications
| Brand | Baja Designs |
|---|---|
| Part number | 447758 |
| Light series | S8 |
| Size | 50 inch |
| Watts | 300 |
| Lumens | 31750 |
| Amp draw | 20 |
| LED life expectancy | 49,930 hours |
| Front lens | Hard coated polycarbonate |
| Bezel | Billet machined aluminum |
| Waterproof rating | IP69K, submersible to 9 ft |
| Mechanical impact | IK10 compliant |
| Mil-spec testing | Exceeds MIL-STD810G |
| Overvoltage protection | Built in |
| Sold as | Kit |
Vehicle fitment
The kit fits 2021–2026 Ford Bronco models. Model years before 2021 and the Bronco Sport fall outside this fitment. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 20 amp draw calls for a fused circuit with a relay, and the toggle switch harness should be wired as the kit lays out. Check local rules for roof-mounted lights before road use.
What’s included
One 50 inch S8 LED light bar, vehicle specific mounting brackets, hardware and a toggle switch wiring harness.










