Overview
The Baja Designs OnX6/S8/XL Pro and Sport Harness 2 Light, part number BAJ640115 (model 640115), is a complete wiring harness for Baja Designs OnX6 and OnX LED light bars. It has a maximum rating of 150 Watts and is universal fit, so it is not built for a specific vehicle.
Key features
- Complete harness for OnX6 and OnX LED light bars
- Two-light configuration
- Maximum rating of 150 Watts
- Strobe and dust modes are referenced for use with the harness
Wiring a two light harness
A two light harness is only as good as its power feed. Connect the positive lead through a fuse at the battery or a dedicated accessory fuse block. If the switch is a small dash or pod switch, run the feed through a relay so the switch does not carry the full load, which helps the switch last longer.
Ground the harness to bare metal on the frame or body, sanding paint off the contact point. A loose ground causes dim lights and heat at the connector. Once wired, bench test the lights before mounting the bars so any wiring error shows up while the work is easy to reach.
- Use a fuse rated for the total load
- Clean and tighten all ground points
- Tie wiring away from belts and hot pipes
Specifications
| Brand | Baja Designs |
|---|---|
| Part number | BAJ640115 |
| Model | 640115 |
| UPC | 819314022963 |
| Compatible bars | OnX6, S8, XL Pro and Sport |
| Maximum rating | 150 Watts |
| Configuration | 2 light |
Vehicle fitment
It is universal fit, so no vehicle year, make or model applies. It is made for the OnX6, S8, XL Pro and Sport light bar lines.
Light bars must be OnX6, S8, XL Pro or Sport models to match this harness.
Installation notes
Match the harness rating to the light bars you connect, and route the wiring away from moving parts and heat. Check local road-use rules before running auxiliary lights on a road vehicle.
What’s included
The harness is a complete two-light kit. Light bars are not part of the package, so you will need compatible bars to complete the setup.









