Overview
The Baer Brakes 6910084 is a left-side, 13.000 inch 1-piece replacement brake rotor with a tall hat, slotted, drilled and zinc-plated. It is a directional rotor for the left side of the vehicle, made for certain Baer Track4, SS4 and other Baer Brake systems. Rotors are sold individually.
The 6910084 pairs a 1.100 inch nominal thickness and 2.232 inch overall height with a 5 x 4.750 inch bolt pattern and a 2.781 inch center bore. Those dimensions are the first things to match against your existing Baer hub and brake system.
Key features
- Left-side directional brake surface
- Slotted, drilled and zinc-plated friction surface
- Tall hat design
- Full cast, one-piece cast iron construction
- Curved vanes intended to help cooling
- Balanced to reduce vibration in use
Before you buy
Brake rotors work with the pads and caliper to slow the wheel, and the friction surface is the part that wears under load. A slotted and drilled surface is designed to channel gas and debris away from the pad face, which can help consistent pedal feel when the brakes heat up. Rotors and pads wear as a pair, so a new rotor is usually fitted with new pads that bed in to its surface.
Before fitting, clean the hub face and remove any rust so the rotor sits flat against it. Check the old rotor for deep grooves, blue discoloration, cracks or a pulsing pedal, which are signs it is worn. Because this rotor is directional, mark the side before removal so the replacement goes on the matching hub. After the first few stops, re-check lug nut torque and listen for noise from the hub.
- Inspect pads and caliper hardware at the same time as the rotor
- Check the hub bearing and wheel studs for play or damage
- Confirm the rotor is compatible with your caliper before fitting
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6910084 |
| UPC | 844165034520 |
| Axle | Left |
| Outside diameter | 13.000 inch |
| Nominal thickness | 1.100 inch |
| Stud/lug hole circle diameter | 4.750 inch |
| Stud/lug hole quantity | 5 |
| Center hole diameter | 2.781 inch |
| Overall height | 2.232 inch |
| Material | Cast iron |
| Construction | Full cast, one piece |
| Surface type | Slotted, drilled and zinc plated |
| Solid or vented type | Vented |
| Directional or non-directional brake surface | Directional |
| Grade type | Performance |
| ABS tone ring included | No |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
It is made for certain Baer Track4, SS4 and other Baer Brake systems. Confirm the bolt pattern, hat height and center bore against your existing system before ordering.
Installation notes
Fit the left-side rotor only to the left hub, since the directional design is side-specific. Check the 2.781 inch center bore, the 5 x 4.750 inch pattern and the 2.232 inch overall height against the hub and caliper bracket before fitting. Have a qualified technician install and test brake rotors on your vehicle.
What’s included
One left-side replacement rotor, sold as each.
Not included: An ABS tone ring, since the rotor is listed without one.
