Overview
The Baer Brakes 6910382 is a left-side, one-piece replacement brake rotor with an 11.625 inch outside diameter, finished slotted, drilled and zinc-plated, and made for select Baer Brake systems. Shoppers searching for a left Baer rotor in this size and hat configuration can check the part number, UPC and specifications below.
The rotor is a one-piece full cast design in cast iron, rated as a performance grade. Its curved vane design is intended to improve cooling, and the rotor is dynamically balanced for vibration-free running. It is directional and made for one side only, so it is a left-side part. Match it to your Baer brake system before buying.
Key features
- Left-side directional rotor, with the vane direction set for one side of the vehicle.
- Curved vane design intended for improved cooling.
- One-piece full cast construction in cast iron.
- Slotted, drilled and zinc-plated surface.
- Dynamically balanced for vibration-free running.
- Drum in hat configuration, with a 3.072 in center hole diameter.
Before you buy a replacement rotor
A replacement rotor takes the place of a worn or warped original and has to match the hub, the caliper position and the brake pads it runs against. Before buying, remove the old rotor and note which side it came from, since a directional rotor only works on the side it was made for. Compare the thickness and bolt pattern of your existing rotor with the new part.
Because the vanes on this rotor run in one direction, mounting it backward works against the cooling design. Check the vane direction against the hub before torquing the wheel studs. Pads are usually replaced along with rotors, and a short bedding procedure after installation helps the new surface build an even layer of pad material.
- Confirm the hub side before unpacking
- Clean the hub face and mounting surface
- Re-check lug nut torque after the first few drives
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6910382 |
| UPC | 844165035251 |
| Sold as | Each |
| Country of origin | USA |
| Axle | Left |
| Construction | Full cast, one piece |
| Material | Cast iron |
| Grade type | Performance |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface type | Slotted, drilled and zinc plated |
| Outside diameter | 11.625 in |
| Nominal thickness | 0.79 in |
| Overall height | 2.325 |
| Center hole diameter | 3.072 in |
| Stud/lug hole quantity | 5 |
| Stud/lug hole circle diameter | 5 in |
| Drum in hat | Yes |
| ABS tone ring included | No |
| Emission code | 6 |
Vehicle fitment
It is a replacement for select Baer Brake systems. Confirm your vehicle’s year, model and trim before ordering, and confirm which Baer system uses this 11.625 inch left rotor.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install this rotor on the left hub only, with the vanes running in the direction Baer designed. The ABS tone ring is not included, so keep the existing ring from the old rotor if your hub uses one.
What’s included
One left-side replacement rotor. Rotors are sold individually.
Not included: ABS tone ring.
