Overview
The Baer Brakes 6920084 is a one-piece, slotted, drilled and zinc-plated replacement brake rotor for the right side of certain Baer Track4, SS4 and other Baer Brake systems. It measures 13.000 inch in outside diameter by 1.100 inch thick and uses a tall hat with a 5 x 4.750 inch bolt circle.
Overall height is 2.232 inch and the center hole diameter is 2.781 inch. The rotor is directional, so it installs on one side of the vehicle only. Curved vanes support cooling, and the casting is dynamically balanced.
Key features
- Tall hat design with 2.232 inch overall height
- Slotted, drilled and zinc-plated friction face
- One-piece vented full cast iron construction
- Curved vanes intended for cooling
- Directional right-side rotor with 5 studs on a 4.750 inch bolt circle
Installing a tall hat rotor
A tall hat rotor carries the braking surface farther from the hub face, so the caliper and pad set must clear the increased overall height. Before ordering, compare the hub face, bearing and caliper bracket against the rotor’s dimensions and confirm that the wheel offset still leaves room for the caliper. Replacement rotors are often fitted with new pads, so the pad set should match both the caliper and the friction face.
Slotted and drilled faces help shed gas and water, but they also put more stress on pads and can wear them faster in heavy stop-and-go use. Bedding in new pads and rotors gradually builds an even transfer layer and reduces noise. Zinc plating protects the hat and friction surface from surface rust during storage, and light rust on the friction face usually cleans off after a few stops.
- Check hub face runout with a dial indicator before torquing the lug nuts
- Clean the hub mating surface and remove any rust before installation
- Replace the ABS tone ring if the hub setup requires one
- Look for lips at the outer edge, grooves, or pulsation under braking as signs of wear
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6920084 |
| UPC | 844165035992 |
| Axle position | Right |
| Construction | Full cast, one piece |
| Material | Cast iron |
| Rotor type | Vented |
| Surface type | Slotted, drilled and zinc plated |
| Brake surface | Directional |
| Outside diameter | 13.000 inch |
| Nominal thickness | 1.100 inch |
| Overall height | 2.232 inch |
| Stud/lug count | 5 |
| Stud/lug bolt circle | 4.750 inch |
| Center hole diameter | 2.781 inch |
| Hat style | Tall hat |
| Grade type | Performance |
| ABS tone ring included | No |
| Emission code | 6 |
| Country of origin | USA |
Vehicle fitment
It is made for certain Baer Track4, SS4 and other Baer Brake systems. Confirm your exact system and fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the 2.232 inch overall height and 1.100 inch thickness against your hub and caliper setup before fitting. Install on the right hub only, and match the 5 x 4.750 inch bolt circle and 2.781 inch center hole.
What’s included
One right-side tall hat replacement rotor, sold individually.
Not included: ABS tone ring.
