Overview
The Baer Brakes 2000046 is a pair of 0.5 inch thick aluminum 5-lug wheel spacers for 5×5.0 and 5×5.50 bolt patterns. Spacers like this push the wheel outward on the hub, and Baer names increased brake clearance, a wider track and better wheel appearance as the reasons to fit them. The spacer is machined from 6061-T6 billet aluminum and finished in clear anodized silver.
At 0.5 inch, this is a thick spacer, so the stud checks below matter more than they would on a thin one. It has a 3.075 inch center bore and 0.625 inch stud holes, is sold as a pair and is made in the USA. No vehicle fitment is listed, so match the bolt pattern and bore to your hub before buying.
Key features
- Brake clearance increase named by Baer
- Wider track named by Baer
- Appearance benefit named by Baer
- 6061-T6 billet aluminum, machined in-house
- Clear anodized finish in silver
- Five lug holes with 0.625 inch diameter
- Sold in pairs, made in the USA
Running a thick spacer
A half-inch spacer lengthens the lever arm between the hub and the wheel, so the studs bend more under cornering and braking loads. Stud material and thread condition matter more at this thickness. Old studs with rust or stretched threads are poor candidates, and replacements should match the strength of the originals.
Extended studs also need enough thread for the lug nuts to clamp fully. Recheck torque after the first few drives, since aluminum spacers can settle slightly against the hub. Keep the faces clean and dry, and inspect the spacer edges for cracks each time the wheels come off.
- Use studs matched to the spacer thickness
- Replace studs with rust or thread damage
- Retorque lug nuts after the first few drives
- Check wheel bearings if the wheel feels loose
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 2000046 |
| UPC | 844165004813 |
| Material | 6061-T6 billet aluminum |
| Finish | Clear anodized |
| Color | Silver |
| Thickness | 0.5 inch |
| Bolt pattern | 5×5.0, 5×5.50 |
| Lug holes | 5 |
| Center bore | 3.075 inch |
| Stud hole | 0.625 inch |
| Spacer OD | 7.000 inch |
| Quantity | Pair (2 spacers) |
| Grade | Premium |
| Country of origin | US |
Vehicle fitment
Choose the spacer by hub dimensions: the 5×5.0 or 5×5.50 bolt pattern, the 3.075 inch center bore and the 0.625 inch stud holes. Matching the bolt pattern alone is not enough, because the bore and stud holes must match too. Confirm fit for your vehicle’s year, model and trim before ordering.
Spacers at this thickness need every hub measurement checked, not just the bolt pattern. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Baer’s note on stock studs puts the practical ceiling at 1/4 inch (.250) for most cars, and at 0.5 inch this spacer is double that figure. Studs must be checked for length and thread engagement before any install. Mounting hardware is not included, and the spacer should not go onto studs that show little thread engagement.
What’s included
2 wheel spacers, sold as one pair.
Not included: mounting hardware.












