Overview
Part number 05575-020 is a pair of vented, cross-drilled and slotted front brake rotors from Baer Brakes, made for the front axle of two-wheel-drive Chevrolet, GMC and Isuzu trucks and SUVs from 1991 to 2003, including the S10, Blazer, Sonoma, Jimmy and Hombre.
The Claw design lets gas and dust escape from between the pad and the rotor, which supports a more consistent pedal and reduced brake fade. Each rotor has a zinc-plated finish and a one-piece full cast body in cast iron. The ABS tone ring is included with the set, which matters on vehicles that use a tone ring for ABS. The outside diameter is 266.7, the overall height is 51 and the discard thickness is 24.5.
Key features
- Vented rotor design rather than solid.
- Slotted and drilled friction surface with chamfered cross-drilled holes.
- ABS tone ring included with the set.
- One-piece full cast construction in cast iron.
- Zinc-plated disc finish with a directional brake surface.
- Premium grade type and emission code 6.
Trucks, tone rings and daily use
Front brakes do most of the stopping on these two-wheel-drive trucks and SUVs, since weight shifts forward under braking. Vented rotors move air between their two faces, which helps them shed heat during repeated stops, such as stop-and-go driving or towing, though they still need good pads and clean hub faces to run true.
Because the ABS tone ring is part of this set, check that the ring sits flat and that the sensor gap is correct before reassembly. A bent or damaged ring can cause ABS warning lights or erratic wheel speed readings. Front wheel bearings and steering components should be inspected at the same time, since looseness there shows up as runout and vibration.
- Torque lug nuts in a star pattern
- Re-check lug torque after a short drive
- Inspect front brake hoses for wear
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 05575-020 |
| UPC | 844165001263 |
| Sold as | Set |
| Axle | Front |
| Drive | 2WD |
| Solid or vented | Vented |
| Rotor construction | One piece, full cast |
| Surface type | Slotted and drilled |
| Material | Cast iron |
| Disc finish | Zinc plated |
| Brake surface | Directional |
| Grade type | Premium |
| Stud/lug hole quantity | 5 |
| Mounting bolt hole circle diameter | 121 |
| Outside diameter | 266.7 |
| Overall height | 51 |
| Discard thickness | 24.5 |
| ABS tone ring included | Yes |
| Emission code | 6 |
Vehicle fitment
The front axle of these two-wheel-drive models is covered: the 1991-2003 GMC Sonoma, the 1994-2003 Chevrolet S10, the 1991-1994 Chevrolet S10 Blazer, the 1995-1997 Chevrolet Blazer, the 1992-1997 GMC Jimmy, the 1991 GMC S15 Jimmy and the 1996-2000 Isuzu Hombre.
Four-wheel-drive versions and model years outside the ranges above are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The ABS tone ring comes with the set, so confirm it seats properly on the new rotor and that the ABS sensor has clearance before the wheel goes back on. Clean the hub face and rotor mating surface first. Brake work should be done with the vehicle raised and supported on stands.
What’s included
Two front rotors, sold as a set, with the ABS tone ring included.
Not included: Pads and front brake hardware are not part of the set.
