Overview
Bilstein’s B8 6112 coilover leveling kit, number 47-260337, raises the front end 0 to 2.75 in. on 2000–2006 Toyota Tundra trucks, depending on application. It adds ground clearance, supports larger tires and increases wheel travel. It fits 2000–2006 Tundra trucks in Base, Limited and SR5 trims.
Two 60MM shocks are paired with custom cold wound coil springs and billet aluminum spring seats. The spring seat sits in one of several snap-ring grooves, so where the lift lands within the 0 to 2.75 in. range depends on which groove you use. The large 60mm digressive piston is meant to give damping control on pavement and in rough terrain.
Key features
- Front lift range of 0 to 2.75 in. set by groove position
- Digressive 60mm piston for damping control
- Cold wound coil springs custom matched to the kit
- Billet aluminum spring seats
- Zinc plated finish with no reservoir
Setting the right front height
Coilover leveling works by moving the spring seat between snap-ring grooves in the body. Each groove changes the lift, so the height is set by where the seat sits rather than by spacer thickness. Pick the groove with care and measure ride height before and after each change.
Before choosing a setting, look at the load the truck carries. A heavier load or a tow setup may call for a firmer spring arrangement, while lighter use often suits a lower groove. Also check that the shock length and brake lines allow the new height without strain at full travel.
Worn ball joints, bushings and sway bar links are common parts to inspect when the front is lifted, since the new height changes their angles. Recheck the alignment and the tightness of the spring seat hardware after the first few drives on uneven roads.
- Keep spring seats clean and free of corrosion
- Match the groove on both sides for even height
- Check shock travel with the wheels turned
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 47-260337 |
| UPC | 651860780566 |
| Front lift | 0 to 2.75 in. |
| Spring type | Custom matched cold wound coil |
| Spring seats | Billet aluminum |
| Body | 60mm ID snap ring grooved, coilover |
| Reservoir | None |
| Finish | Zinc plated |
| Position | Front |
Vehicle fitment
Fits 2000–2006 Toyota Tundra trucks in Base, Limited and SR5 trims.
Tundra model years after 2006 and other Toyota trucks are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Changing the spring seat position means moving between snap-ring grooves in the body. Measure ride height after each change to confirm the lift.
What’s included
Two 60MM shocks, two coil springs and two billet aluminum spring seats.









