Overview
The TeraFlex 3990220 is a rear axle trackbar mount for Jeep Wrangler TJ models, sold as a single raw steel bracket. It relocates the track bar mounting point to allow lift and is designed to replace the weaker factory mounts. The mount is precision laser cut from 3/16 inch steel and formed for correct suspension geometry.
The mount is designed for Dana 44 or Dana 60 axles with a 3 inch diameter axle tube. Welding is required for installation. The mount is ready for welding and then paint or powder coating after it is fitted.
Key features
- Precision laser cut from 3/16 inch steel
- Relocates the mounting point to allow lift
- Replaces weaker factory mounts
- Sold in raw steel, ready for welding and paint or powder coating
- Designed for Dana 44 or Dana 60 axles with a 3 inch diameter axle tube
Relocating a rear track bar mount
A raw steel relocation mount lets the track bar attach to the axle at a point that keeps it working better after a lift. Factory mounts are usually designed for stock height, so moving the mounting point helps maintain the track bar angle when the axle sits higher.
Fabrication quality matters. Clean the axle tube where the mount sits, fit the mount squarely, and use the tack and weld sequence that keeps the part from distorting. Finish the steel after welding to help it resist rust.
Inspect the welds and the axle tube periodically, especially on vehicles used off road. Look for cracks around the weld edges and check the track bar bushings, since a shifted mount can change how the axle centers.
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 3990220 |
| UPC | 843885002598 |
| Mounting location | Rear axle |
| Material | 3/16 inch steel |
| Finish | Raw steel, ready for paint or powder coating |
| Axle compatibility | Dana 44 or Dana 60 with 3 inch diameter axle tube |
| Quantity | One trackbar mount |
Vehicle fitment
The manufacturer fitment list covers 2004 to 2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon, and 1997 to 2006 Jeep Wrangler (TJ) in several trims.
Wrangler JK, YJ and other generations are not covered by this mount. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, so the mount is welded to the axle as part of the installation. Check that your axle matches the Dana 44 or Dana 60 specification with a 3 inch tube before you cut or weld anything. Weld only with proper eye and skin protection.
What’s included
This kit includes one trackbar mount.









