Overview
The Artec Industries Leaf Spring Perch and Plates, part number A/IBR1034, are a pair of leaf spring mounts made for spring over axle (SOA) swaps and Artec Modular Truss builds. The perch and plates spread the load across four bolts instead of two U-bolts, a design intended to add strength for spring over axle builds.
The mount has three leaf pin positions for one inch adjustments forward or back. Its top plates and perches are 3/8 inch thick, the gussets are 1/4 inch thick, and truss end caps are included for joining Artec Modular Trusses. It is for off-road use only.
Key features
- Spreads the load across 4 bolts rather than 2 U-bolts
- Three leaf pin positions for one inch adjustments forward or back
- Variable axle tube diameter; grind off the tabs for larger tubes
- Current notch fits 3.25-3.375 inch axle tubes
- Includes truss end caps for Artec Modular Truss
- Sold as a pair
Spring over axle basics
A spring over axle swap moves the leaf springs to the top of the axle, which changes how the axle sits under the vehicle and how the mounts carry load. Perches and plates like these replace U-bolts by clamping the spring to the axle through a wider footprint. Pinion angle and driveshaft length should be checked after any change in ride height or spring position.
Leaf pack thickness, shackle length and bushing condition all affect how the mount performs. Before fitting, inspect the spring eye, the shackle hardware and any worn bushings, since loose parts shift the load onto the bolts. Keep the axle tube clean where the perch will seat, and dry-fit the mount before final tightening.
- Measure the axle tube before buying hardware
- Check pinion angle after final ride height
- Recheck nuts after the first few off-road runs
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | A/IBR1034 |
| Type | Spring mount |
| Sold as | Pair |
| Top plates and perches | 3/8 inch thick |
| Gussets | 1/4 inch thick |
| Leaf pin positions | Three, one inch adjustments forward or back |
| Axle tube fit | Current notch fits 3.25-3.375 inch tubes; tabs can be ground off for larger tubes |
| Tube diameter | Any, variable |
| Hardware | Not included |
| Fitment label | Universal fit (manufacturer label) |
Vehicle fitment
It is a universal fit suspension mount, not a vehicle-specific bracket. Fit depends on axle tube diameter and leaf pack thickness, so match it to your axle and spring setup.
This is a suspension mount rather than a vehicle-specific bracket, so confirm your axle tube diameter before installing.
Installation notes
Hardware is not included because leaf pack thickness can vary, so select hardware to suit your pack. Artec recommends grade 8 hardware and nylon locking nuts. Grind off the tabs only if your axle tube is larger than the current notch fits. This part is for off-road use only.
What’s included
A pair of leaf spring perches and plates, with truss end caps.
Not included: hardware, because leaf pack thickness can vary.










