Overview
The ARB CS005RA is a two-stage leaf spring from ARB 4×4 Accessories, part number CS005RA. The primary stage supports the vehicle unladen, and the secondary stage adds capacity when a heavier load is carried. Confirm fit for your vehicle’s year, model and trim before ordering, including the axle and mounting points.
The leaves are diamond cut and draw tapered so the load is spread over a larger surface and the leaf ends see less stress. ARB uses graphite coating and nylon interleaf liners to reduce friction, and it shot peens the tension side of each leaf. Each spring is scragged to keep its set and load tested against the specification.
The leaf tips are where stress concentrates in any leaf spring, so the diamond cut profile and the nylon liners are aimed at that point. The shot peened tension side adds resistance to fatigue on the face of each leaf that bends the most. Together these choices are the reason the design is built the way it is.
Two-stage packs are chosen to keep the ride reasonable when the vehicle is light and to add capacity when it is loaded. The primary leaves handle the first part of the travel, and the secondary leaves join once the spring has flexed far enough. For this part, ARB pairs that design with diamond cut leaves and shot peened tension sides.
Key features
- Draw tapered leaves spread the load over a larger area.
- Diamond cut leaf ends reduce the stress that builds up at the tips.
- Fully scragged so the spring keeps a set and resists sagging.
- Load tested to the required specification.
- Graphite coated leaves for lower friction between them.
- Regreasable nylon interleaf liners at the leaf tips.
- Shot peening on the tension side of all leaves.
Care for the leaf tips
The leaf tips carry the highest stress in a leaf spring, so they are the first place to look during routine checks. Diamond cut ends and draw tapered leaves reduce the concentration of load at those points, but the tips still rub against their neighbors as the spring flexes. Keeping the nylon interleaf liners greased helps the leaves slide instead of binding, which protects the tips and the surfaces around them.
Two-stage packs add a second point of contact as the spring deflects, so wear can show up on the secondary leaves before it appears on the primary set. When the spring is out, look at both stages, clean away grit and check for fretting, cracks or rust forming between the leaves. Dirt packed into the pack holds moisture against the steel and speeds up wear.
- Grease nylon liners after mud and water crossings
- Check leaf tips for fretting and cracks
- Clean grit from between the leaves
- Inspect clamp hardware during removal
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | CS005RA |
| UPC | 700007219101 |
| Type | Leaf spring |
| Leaf pack | Two-stage |
| Leaf ends | Diamond cut, draw tapered |
| Liners | Regreasable nylon interleaf |
Vehicle fitment
Confirm the axle, mounting points and load rating against your vehicle before ordering.
What’s included
One leaf spring. Check the package contents against your installation before starting.



