Overview
The Advance Adapters Output Shaft Kit, part number 50-3034, is an upgrade kit for the Dana 300 transfer case. It replaces the stock 1-1/8 in diameter, 26 spline output with a 1-3/8 in, 32 spline output shaft that Advance Adapters presents as a stronger option.
This kit targets the output shaft of the Dana 300 transfer case. It adds a short output shaft with a 1310 non-CV yoke.
Key features
- Upgrades the output from 26 spline to 32 spline
- 1-3/8 in output shaft diameter
- Short output shaft with 1310 non-CV yoke
- Kit includes new output shaft, rear tail housing, yoke, bearings, seals and hardware
Output shaft wear and upgrades
The output shaft carries the drive from the transfer case to the rear driveline, so its splines and bearing surfaces take steady load. Wear often shows up as clunking when the drive engages, vibration that changes with speed, or fluid around the rear housing. Inspecting the shaft and seals at the same time as an upgrade keeps the new parts from wearing against a worn surface.
A short output shaft changes the distance between the transfer case and the driveline, so driveshaft length and angles should be checked after the swap. Yoke type matters too: a non-CV yoke suits a driveline set up for it, and a different yoke style may need a different joint. Re-check the bolts and yoke retention after the first few trail runs.
- Check driveshaft angles after the output shaft is replaced
- Inspect the rear tail housing mounting surfaces for damage
- Refill the transfer case to the correct level after the job
Specifications
| Brand | Advance Adapters |
|---|---|
| Part number | 50-3034 |
| UPC | 70000216200 |
| Transfer case | Dana 300 (Dana Model 300) |
| Stock output shaft | 1-1/8 in diameter, 26 spline |
| Upgraded output shaft | 1-3/8 in diameter, 32 spline |
| Yoke | 1310 non-CV |
| Shaft type | Short output shaft |
Vehicle fitment
The kit is made for the Dana 300 transfer case. Confirm fit for your vehicle’s year, model and trim before ordering, and check that your case is a Dana 300 first.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Output shaft work means opening the rear of the transfer case, so drain the fluid first and support the vehicle on stands. A shop familiar with Dana 300 cases is a sensible choice for this job.
What’s included
The kit includes a new output shaft, rear tail housing, yoke, bearings, seals and other necessary hardware.
Not included: The transfer case itself and the driveshaft are not included with the kit.









