Overview
The Advance Adapters 716693-LS is an aluminum conversion radiator with 1 inch wide core tubes and 16 fins per inch. Confirm fit for your vehicle’s year, model and chassis before ordering.
Coolant flows through the tubes and transfers heat to the fins, which are cooled by airflow from the fan and vehicle speed before the coolant returns to the engine. Advance Adapters says each radiator is air tested 3 times during the build, and that the 1 inch tubes and fins are designed for heat dissipation.
Key features
- Aluminum core with 1 inch wide tubes and 16 fins per inch
- Cross flow design that places the radiator cap on the low-pressure cold side
- Billet filler neck for a standard GM overflow style cap with 3/4 inch depth
- Temperature sensor provision using a 3/8 inch NPT fitting on the cold side of the tank
- TIG welded construction with no epoxies
- Aluminum angle mounting flange with no bolt holes, so the mounting pattern is chosen by the installer
- Two 1/4 inch NPT fittings welded into the tank for transmission cooler lines
Airflow and heat transfer
Heat leaves a radiator through the fins, so airflow is the main factor in how well any core performs. Keep the fins clear of debris and bent sections, since a bent fin reduces contact area and lowers cooling capacity. Grille screens, bug shields and aftermarket bumpers can also block air, so check them when setting up a new core.
Fan choice and shroud fit go together. A fan that sits at the wrong depth, or a shroud that does not seal to the core, can cut airflow at low speed, which is when most overheating happens. Recheck fan clearance after the mounts are set, especially where the installer has chosen the height. A thermostat stuck closed also limits heat rejection, so test it during installation.
- Clean the fins before installation
- Check fan clearance at full travel
- Test the thermostat when the system is refilled
Specifications
| Brand | Advance Adapters |
|---|---|
| Part number | 716693-LS |
| UPC | 700008347981 |
| Type | Conversion |
| Core material | Aluminum |
| Core tube width | 1 inch |
| Fins | 16 per inch |
| Welding | TIG welded, no epoxies |
| Filler neck | Billet, for a standard GM overflow style cap with 3/4 inch depth |
| Recommended cap pressure | 15 lbs. to 22 lbs. |
| Temperature sensor provision | 3/8 inch NPT, cold side of tank |
| Transmission cooler fittings | Two 1/4 inch NPT, welded into tank |
| Included fittings | Two 1/4 inch male NPT x 5/16 inch inverted flare |
| Mounting flanges | .083 inch, aluminum angle with no bolt holes |
Vehicle fitment
Fit depends on your engine, transmission and mounting location. Confirm fit for your vehicle’s year, model and trim before ordering.
Because the mounting flange has no bolt holes, the installer sets the mounting pattern and height. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The mounting flange is an aluminum angle with no bolt holes, so the installer sets the pattern and height. This lets the radiator center on the water pump with a new engine location and helps when a body lift is installed.
A standard GM overflow style cap with 3/4 inch depth fits the billet filler neck, and the recommended cap pressure is 15 lbs. to 22 lbs. A higher pressure cap raises the boiling point and keeps fluid in the cooling system.
What’s included
The package includes two 1/4 inch male NPT x 5/16 inch inverted flare fittings. This radiator can be ordered with or without a transmission cooler, so check the package contents before starting.









