Overview
The Rugged Ridge 11235.33 is a 3/4 inch D-ring isolator built to stop recovery shackles from banging against a bumper. It is made of polyurethane, which absorbs the impacts that would otherwise make the familiar clang on rough trails. It is universal fit, so the shackle size matters more than any vehicle year, model or trim.
The design wraps the whole shackle body rather than only the top. Polyurethane covers the outer edge, and urethane washers fill the gap between the pin and the mounting tab. Rugged Ridge also makes this design for 7/8 inch shackles.
Key features
- Molded polyurethane shell that snaps over the outer shackle perimeter
- Urethane washers that keep the shackle pin from touching the mounting tab
- Designed to virtually eliminate the noise from shackles hitting nearby metal
- Designed for 3/4 inch shackles
- Set includes 2 isolators and 4 washers
- Offered in Black, Red, Green, Yellow and Pink
Pin and tab wear
The pin and the mounting tab are where a shackle works hardest. Every bump pushes the pin against the tab hole, and over time that contact can enlarge the hole or polish the pin. A washer placed between them spreads that load and keeps the metal apart, which slows the wear and keeps the shackle steady when the rig flexes on uneven ground.
Polyurethane parts also change with time. Sun and heat can harden the shell, and a hardened sleeve may crack instead of flexing. Store recovery gear out of direct sunlight and wipe the isolator clean after muddy trips. Replace any part that has lost its shape, since a worn sleeve no longer covers the contact point it was fitted to protect.
- Inspect the tab hole for enlargement or polished metal
- Replace washers that crack or flatten
- Keep the pin clean and lightly greased
- Store spare parts out of direct sun
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11235.33 |
| UPC | 804314290818 |
| Material | Energy-absorbing polyurethane with urethane washers |
| Shackle size | 3/4 inch |
| Contents | 2 isolators and 4 urethane washers |
| Colors in line | Black, Red, Green, Yellow, Pink |
| Fitment | Universal fit |
Vehicle fitment
Universal fit, so the part is not tied to a vehicle. The isolator is matched to the shackle, and this part number is for 3/4 inch shackles.
Measure the shackle diameter first; Rugged Ridge also makes a 7/8 inch version.
Installation notes
Work the polyurethane shell over the shackle body until it seats, then place a washer on each side of the mounting tab at the pin. Check that the shell covers the shackle where it contacts the bumper before the isolator goes into use.
What’s included
Two isolators and four urethane washers, packed together.
Not included: the recovery shackle.


















