Overview
The Trail Gear 110043-1-KIT is a front solid axle U-bolt flip kit with two flip plates and four 9/16 in bolts with nuts and washers. It accommodates spring packs up to 2.5 in. thick and requires crossover steering for installation.
Trail Gear explains that stock U-bolts face down and can catch rock and trail debris. The flip kit points the spring bolt up and out of the way, which the brand says improves ground clearance and reduces damage to the threaded section of the bolt.
Key features
- Front solid axle application
- Two flip plates included
- Four 9/16 in bolts with nuts and washers
- Spring pack capacity up to 2.5 in. thick
- Crossover steering required
Installation planning
Front solid axle flip kits move the U-bolt so the spring bolt clears rock and debris on the trail. The position of the plates matters because each plate has to sit flat against the axle and the spring pack. Measure the spring pack thickness before ordering and compare it with the kit’s limit, since a thicker pack can change how the plates seat.
Crossover steering affects how the front axle can be installed, so inspect the steering linkage and tie rods before starting the flip. Replacing worn steering parts at the same time keeps the job predictable. Once the kit is fitted, re-check the nuts after the first drives, particularly on rough ground.
- Measure spring pack before ordering
- Check steering linkage and tie rods
- Re-check nuts after first drives
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110043-1-KIT |
| UPC | 70000621384 |
| Application | Front solid axle |
| Spring pack capacity | Up to 2.5 in. thick |
| Bolts | Four 9/16 in with nuts and washers |
| Plates | Two flip plates |
| Steering | Crossover steering required |
Vehicle fitment
It is a front solid axle flip kit, so confirm the axle position first. Spring packs up to 2.5 in thick fit this kit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Crossover steering is required for installation, so plan for that before fitting the flip plates. Measure the spring pack and confirm it is no thicker than 2.5 in. before fitting.
What’s included
Two flip plates, four 9/16 in bolts with nuts, and washers.
Not included: Crossover steering is required for installation but is not included with this kit.








