Overview
The Trail Gear 140053-1 is a knuckle stud cone washer for 1979-1985 Toyota front solid axle knuckles and the 1990-1997 Toyota FJ80 Landcruiser. It is factory Toyota knuckle hardware and is a direct fit for those applications.
Knuckle stud washers and wear
A cone washer sits between the knuckle face and the stud nut. Its cone shape centers the nut and spreads clamping load across a wider area, which helps keep the stud seated. On a solid axle knuckle, that seating surface carries repeated flex from trail use, so the washer is part of how the joint stays tight.
Wear shows up as flattening on the cone face, cracks, or rust that builds between the washer and the knuckle. Any of these can allow the nut to back off gradually. Clean the knuckle face and the stud threads before reassembly, and make sure the washer sits square rather than tilted.
Whenever a knuckle is taken apart, inspect the washer and the stud at the same time. Replacing a worn washer with a new one keeps the seating surface consistent and reduces the chance of a slow loosening that is hard to notice in the field.
- Look for flattening on the cone face
- Check for cracks or heavy rust
- Clean the knuckle face before reassembly
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140053-1 |
| UPC | 70000621622 |
| Hardware type | Factory Toyota knuckle hardware, knuckle stud cone washer |
Vehicle fitment
It fits 1979-1985 Toyota front solid axle knuckles and the 1990-1997 Toyota FJ80 Landcruiser. Confirm your knuckle and vehicle year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Knuckle stud cone washer. Count the washers you receive against the studs on each knuckle.
Not included: Knuckle studs and other knuckle hardware. Have these on hand before fitting the washer.









