Overview
The Trail Gear Super Metal Knuckle Stud kit, part number 186116-1-KIT, is a replacement knuckle stud for steering knuckle repairs and upgrades. It fits the 1979–1985 Toyota front solid axle knuckle and the 1990–1997 Toyota FJ80 Landcruiser.
The stud is made from a proprietary metal and is 0.250 in (1/4 in) longer than stock to fit aftermarket steering arms. It has an integrated 8mm hex head for removal.
Key features
- Proprietary metal made exclusively for Trail Gear
- Test results exceed Class 12.9 standards.
- 0.250 in (1/4 in) longer than stock to accommodate aftermarket steering arms
- Integrated 8mm hex head for easy removal
- Intended for high-steer system repairs and upgrades
Before installing knuckle studs
Steering knuckle studs hold the knuckle to the hub assembly and carry steering and braking forces, so the job affects how the vehicle tracks. Before pulling anything apart, inspect the ball joints, tie rod ends, wheel bearings and the knuckle bore for wear. Replacing a stud on a worn knuckle may only hide a larger problem, and the new stud will not sit correctly in a damaged bore.
Aftermarket steering arms often change the geometry, so an alignment check is a sensible step after the work is finished. Clean the threads and the stud seat thoroughly, since grit can prevent the stud from seating fully. Keep the wheel off the ground while you check for play, and move the steering by hand to feel for looseness before driving. Keep a record of what was replaced so later service is easier.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 186116-1-KIT |
| UPC | 70000680779 |
| Material | Proprietary metal made for Trail Gear |
| Length | 0.250 in (1/4 in) longer than stock |
| Head | Integrated 8mm hex |
| Strength | Exceeds Class 12.9 standards in Trail Gear testing |
| Stud torque | 40 ft-lbs in the knuckle |
| Stud nut torque | 75–80 ft-lbs |
Vehicle fitment
It fits 1979–1985 Toyota front solid axle knuckles and the 1990–1997 Toyota FJ80 Landcruiser.
Other Toyota generations and axle styles are not covered. Check fit against your year, model and trim before ordering.
Installation notes
Trail Gear recommends Locktight on the lower threads when installing knuckle studs. Tighten the studs to 40 ft-lbs in the knuckles and the stud nuts to 75–80 ft-lbs. Steering knuckle work affects steering control, so have a qualified technician check the repair if you are unsure.
What’s included
Check the package contents against your installation before starting.
Not included: Stud nuts and Locktight are not included in the kit, so have them on hand before installing.









