Overview
The Omix-Ada 16714.03 is a front wheel stud for the 1967-1969 Jeep CJ5. It is a Dana 44 wheel stud for drum brakes with a right hand thread, and 5 studs are required.
It is a direct OE replacement built to original specifications and comes with a limited five year warranty.
A wheel stud is the threaded bolt pressed into the hub or axle flange that a lug nut tightens onto. The 16714.03 is a front stud with a right hand thread for a Dana 44 axle with drum brakes. It is for the 1967-1969 Jeep CJ5 in Base trim, so it suits owners restoring or repairing a vintage CJ5.
Compare stud length, diameter and thread pitch against the stud being replaced before installing. Five studs are needed, so confirm whether that count is per wheel or per vehicle before ordering.
Key features
- Front wheel stud
- For Dana 44 axles with drum brakes
- Right hand thread
- Direct OE replacement from Omix-Ada
- Five studs required
- Limited five year manufacturer warranty
Before replacing studs
A worn or damaged wheel stud can strip threads, loosen under load or fail in the hub flange. Check each stud for bent shanks, stripped or crossed threads, and rust around its base. Replacing one stud is rarely enough if the others show the same wear, so inspect the whole set when the wheel is off.
Studs are press fit in most hubs, so removing a stud usually means pressing out the old one and seating the new one squarely. Clean the hub bore first and avoid tapping the stud head with a hammer. After installation, check for wobble with the wheel mounted and re-torque the lug nuts once the vehicle has been driven a short distance. Keep the matching lug nuts clean and undamaged.
- Check for bent or stripped threads
- Look for rust at the stud base
- Press new studs in squarely
- Re-torque lug nuts after a short drive
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16714.03 |
| UPC | 804314034283 |
| Part type | Wheel stud |
| Axle | Dana 44 |
| Brake type | Drum brakes |
| Thread | Right hand |
| Position | Front |
| Quantity required | 5 |
| Fit type | Direct fit |
| Warranty | Limited five year manufacturer warranty (Omix-Ada) |
Vehicle fitment
The manufacturer fitment list for this part includes:
- 1967–1969 Jeep CJ5 (Base)
Only the 1967-1969 CJ5 in Base trim is covered. Owners of other CJ models or years should not assume the same stud fits, so match the year and trim first.
It fits the 1967-1969 CJ5 only. Other CJ5 years, the CJ6, the CJ7 and the Wrangler fall outside this fit, so match your exact year and trim first.
Installation notes
Wheel studs hold the wheel on the vehicle, so have them installed by a qualified technician. Follow the vehicle service manual for each step.
Tighten lug nuts to the torque specification in the vehicle service manual, and re-check them after the first miles of driving.
What’s included
One wheel stud; five are required.








