Overview
The Omix-ADA 16714.02 is a right hand thread wheel stud for front or rear hubs, sold each. It fits Willys MB, CJ-2 and CJ-3 applications.
Check the thread direction of the hub before fitting, since this stud is made with right hand threads.
Key features
- Right hand threads
- Front or rear hub position
- Sold each
- Built to original specifications
Right hand studs and wheel fit
A right hand thread stud is the standard direction for most wheel hardware, so it is often the replacement that matches a hub without a special check. Even so, confirm the hub’s thread direction against the old stud, since mixing directions on the same hub is a common cause of loose nuts.
Wheel studs carry clamp force from the nut into the hub flange. Replace a stud that shows thread damage, a bent shank or crevice corrosion at the base. Clean the hub face, use the correct nut seat, and check torque after the first few drives to confirm the joint has settled.
- Match the thread direction to the hub
- Replace studs in pairs when one is worn
- Inspect nut seats when changing studs
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16714.02 |
| UPC | 804314067526 |
| Thread direction | Right hand |
| Position | Front or rear |
| Sold as | Each |
Vehicle fitment
It fits the 1941–1942 Willys MB (Base), the 1946–1949 CJ-2 and the 1949–1953 CJ-3.
Cherokee, Wrangler and CJ5 or CJ7 vehicles are not covered by these entries. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The stud is sold each. Check the package contents against your installation before starting.









