Overview
The Trail Gear 130005-1-KIT is a high steer kit for 1984–1995 Toyota 4Runner (DLX, SR5) and 1979–1995 Toyota Pickup models. It replaces the stock steering arms, pitman arm, steering rods and tie rod ends with heavier parts meant for the extra stress that flexible suspension puts on steering.
Modern flexible suspension can load stock steering beyond what it was built to handle, which may break stock steering arms and cause loss of steering at critical moments. The kit uses forged steering arms and heavier rods to handle that load, and it is a precision fit for straightforward assembly.
Key features
- Forged steering arms that Trail Gear describes as super beefy and solid
- Heavy duty pitman arm with a flat design
- Heavy duty steering rods with a .250in wall thickness
- Tie rod ends included with the kit
- Precision fit for easier assembly
- 4 stud configuration
Steering under flexible suspension
Flexible suspension lets the wheels move farther and more often than stock suspension, which adds repeated load to the steering arms and rods. Steering parts sized for a stiffer setup can fatigue over time, and a failure at the wrong moment can take steering control away. Upgrading the arms, pitman arm and rods addresses that stress directly.
Changes like this affect the whole linkage, so the job is best treated as a system rather than a single part. Check the tie rod ends for play, confirm the steering reaches full lock without binding and inspect the wheel bearings for looseness. After assembly, drive slowly on a level road and watch for wander, pull or vibration before heading out on trails.
- Check tie rod ends and drag link for play
- Confirm full steering lock without binding
- Inspect wheel bearings before the first trip
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 130005-1-KIT |
| UPC | 70000621412 |
| Kit type | High steer kit |
| Stud configuration | 4 stud |
| Pitman arm | Flat, heavy duty |
| Steering rod wall thickness | .250in |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for 1984 to 1995 Toyota 4Runner (DLX and SR5) and 1979 to 1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5 and SR5 Turbo) models.
Toyota models and years outside these two entries, including 4Runner years before 1984 or after 1995, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A high steer kit changes steering geometry, so have the front alignment checked after installation.
What’s included
The kit includes the forged steering arms, the heavy duty pitman arm, the steering rods and the tie rod ends.








