Overview
The M.O.R.E. (Mountain Off Road Enterprises) Steering Correction Kit Stage One, part number 9930, is a steering system for 1987–1995 Jeep Wrangler YJ models with spring over axle suspension. M.O.R.E. developed it to keep steering working through full suspension travel without bind.
It works with stock offset wheels or aftermarket wheels, and M.O.R.E. says it suits stock leaf springs over the axle or springs up to 2.5″ of lift over the axle.
Key features
- Designed for full suspension travel without bind
- Works with stock offset wheels or aftermarket wheels
- Simple bolt-on design, with no welding required
- Suits stock leaf springs or lift springs up to 2.5″ over the axle
- Includes knuckle bracket (#9923), tie rod and drag link assembly (#9924), and hardware kit (#9925)
Steering and tire clearance
A spring over axle Wrangler YJ changes steering geometry when the suspension moves, and a correction kit exists to keep the steering linkage working through full travel. Clearance matters here, because a tie rod or drag link that binds at full droop or full compression will wear quickly and affect control.
When choosing wheels and tires, consider both offset and tire width. Stock offset wheels and aftermarket wheels behave differently at the steering knuckle, so check clearance with the steering turned fully in both directions. Rubbing at the inner fender or on the springs is a sign that the setup needs adjustment.
Joints in a steering linkage wear over time. Look for play in the tie rod ends, cracked boots and loose clamps during regular service, especially after off-road use. Keep the steering components clean and recheck fasteners after the first few trips.
Specifications
| Brand | Mountain Off Road Enterprises (M.O.R.E.) |
|---|---|
| Part number | 9930 |
| UPC | 815572020161 |
| Finish | Bare steel |
| Suspension type | Spring over axle (S.O.A.) |
| Lift springs | Up to 2.5″ over the axle |
| Included | Knuckle bracket #9923, tie rod and drag link assembly #9924, hardware kit #9925 |
| Fitment | Direct Fit |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ) in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
The list does not include TJ, LJ or JK Wrangler models or CJ models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit is bolt-on, but M.O.R.E. says minor grinding, drilling and tapping of holes is required. Plan for that work before assembly, and check front alignment after installation.
What’s included
The kit includes the knuckle bracket (#9923), the tie rod and drag link assembly (#9924), and the hardware kit (#9925).








