Overview
The Mountain Off Road Enterprises Steering Correction Kit Stage One, part number 9930Z, is a steering kit for 1987-1995 Jeep Wrangler YJ vehicles with spring over axle (S.O.A.) suspensions. Mountain Off Road Enterprises, also known as M.O.R.E., designed the system for full suspension travel without bind, so the steering keeps working through the full range of suspension movement.
The kit is a bolt-on design that does not require welding. It works with stock offset wheels or aftermarket wheels, and with stock leaf springs over the axle or lift springs up to 2.5 inches over the axle. It is intended for use with 3 to 7 inches of lift only, and the components are zinc plated.
Key features
- Built for 1987-1995 Jeep Wrangler YJ with spring over axle suspensions
- Designed for full suspension travel without bind
- Works with stock offset wheels or aftermarket wheels
- Bolt-on design, no welding required
- Works with stock leaf springs over the axle or lift springs up to 2.5 inches
- Intended for use with 3 to 7 inches of lift only
- Zinc plated finish
- Includes knuckle bracket, tie rod and drag link assembly, and hardware kit
Preparing the YJ for installation
Plan the install around the modifications before the parts go on the vehicle. Minor grinding, drilling and tapping are needed, so mark the holes, check clearance around the frame and axle, and remove any components that get in the way. Doing this work on a clean bench makes the holes easier to place accurately.
Because the kit is bolt-on without welding, the strength of the setup depends on fastener torque and hole alignment. Use the included hardware, tighten each connection, and recheck after the first few drives. Loose steering fasteners are a common cause of wander and noise.
Inspect the old steering components before removing them. Worn tie rod ends, bent drag links, and seized joints are reasons to replace parts at the same time, and a clean setup is easier to align afterward.
Specifications
| Brand | Mountain Off Road Enterprises |
|---|---|
| Part number | 9930Z |
| UPC | 815572020420 |
| Suspension type | Spring over axle (S.O.A.) |
| Lift range | 3 to 7 inches |
| Lift springs supported | Up to 2.5 inches over the axle |
| Finish | Zinc plated |
| Included hardware | Hardware kit (part number 9925) |
Vehicle fitment
It is a direct fit for 1987-1995 Jeep Wrangler YJ models with spring over axle suspensions and is not made for other suspension types.
This kit does not cover the Wrangler TJ, LJ, JK or JL generations. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Minor grinding, drilling and tapping of holes is required for installation. Plan for these modifications before assembly, since the kit does not use welding. Because steering components carry load, check every connection for tightness and inspect the steering before driving.
What’s included
The kit includes a knuckle bracket (part number 9923), a tie rod and drag link assembly (part number 9924), and a hardware kit (part number 9925).








