Overview
The TeraFlex 1813000 is a high steer system for Jeep Wrangler vehicles with the Dana 30 front axle. It fits 2004 to 2006 Wrangler Unlimited (LJ) and 1997 to 2006 Wrangler (TJ) models. It replaces the outer passenger steering knuckle with a custom high clearance knuckle and adds a new tie rod and drag link.
The raised steering arm restores the factory drag link position and returns ride quality to stock levels. The new tie rod and drag link use one ton tie rod ends, and the high strength parts are designed to improve long-term durability of the steering system with the new knuckle.
Key features
- Replaces the outer passenger steering knuckle with a high clearance cast knuckle
- Heavy-duty tie rod and drag link
- One ton tie rod ends
- Tapered inserts
Dana 30 steering upkeep
The Dana 30 front axle carries the steering knuckle and tie rod on a fixed pivot, so a high steer swap changes where the steering loads travel. Owners who run this setup often find that the sway bar end link mounts, brake lines and track bar sit closer to the new tie rod path, which makes careful fitting important before any cutting begins.
Because the tie rod moves, its joints work at different angles than stock. Clean the grease fittings and inspect the boots often, since dirt in a tapered insert or tie rod end wears the joint faster. Watch for sloppy steering, uneven tire wear or a wandering feel on the highway, as these signs point to steering geometry that needs attention.
- Grease the knuckle and tie rod joints on schedule
- Inspect boots for tears after off-road runs
- Recheck welds and mounts after the first outings
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1813000 |
| UPC | 843885023579 |
| Front axle | Dana 30 |
| Knuckle | Heavy-duty cast high steer, replaces outer passenger knuckle |
| Tie rod ends | One ton |
| Inserts | Tapered |
| Steering arm | Raised position |
Vehicle fitment
It fits 2004 to 2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon models, and 1997 to 2006 Jeep Wrangler (TJ) models, including the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
The kit is described only for Dana 30 front axle applications, so Wrangler models with a different front axle are not covered by it. JK and JL models are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting off the sway bar end link mounts and re-welding them in a different position so the tie rod tube clears. This is cutting and welding work, so have it done by someone experienced with steering and frame welding.
What’s included
A heavy-duty cast high steer knuckle, a heavy-duty tie rod and drag link with one ton tie rod ends, and tapered inserts.
Not included: the welding work and the sway bar end link mount changes that the installation requires.









