Overview
The Trail Gear 111308-1-KIT is a greasable bolt measuring 18mm x 150mm, part number 111308-1-KIT. It is supplied as one bolt per unit, and the KIT suffix is part of the part number. It is marked universal fit and names no vehicle.
Key features
- Greaseable bolt
- Size 18mm x 150mm
- One bolt per unit
- Universal fit marking
Choosing and fitting a greasable bolt
A greasable bolt is used as a pivot or mounting pin in suspension and shackle joints. A grease fitting in the head lets fresh lubricant reach the shank and bearing surfaces, which reduces friction and helps keep water and grit from locking the joint. On a vehicle that sees mud and water, this makes a noticeable difference to how freely the joint moves.
Diameter and length both matter. The bolt should slide into the existing hole without forcing, and the threads should engage the nut or mount fully. A bolt that is too short or has worn threads can pull out under load. Check the shank for bends, pitting and corrosion before reusing an old pin, and replace any bolt that has stretched or damaged threads.
Greasing is most effective when the joint is serviced regularly. Pump grease until it shows at the seal, then wipe away the excess so it does not collect grit. Re-tighten the nut to the level called for in your vehicle service manual after the first few trail runs, and check the grease fitting for damage.
- Measure the hole before choosing a bolt
- Check threads for stretching or corrosion
- Grease the joint after every wet trail run
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 111308-1-KIT |
| UPC | 70000621546 |
| Size | 18mm x 150mm |
| Lubrication | Greaseable |
| Quantity | One bolt |
Vehicle fitment
Universal fit is the only marking, and no year, make or model is given. Match the 18mm diameter and 150mm length to your existing shackle or mount hardware before fitting.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One greasable bolt, 18mm x 150mm.
Not included: Nuts, sleeves and other hardware. Check the package contents against your installation before starting.








