Overview
The ARB Shackle And Pin Kit, part number OMEGS15, is a rear leaf spring shackle kit with greasable pins for the 2005–2014 Nissan Xterra in the Off-Road, PRO-4X, S, SE and X trims.
Shackles hold the ends of a leaf spring to the frame and pivot as the spring flexes. This bolt-together design avoids out-of-angle pin contact with the side plate, and each pin has two grease outlet holes.
Key features
- Greasable shackle pins
- Two grease outlet holes in each pin
- Bolt-together design
- Built to avoid out-of-angle pin to side plate contact
- Rear position
Lubrication and inspection routine
Greasable shackle pins only work well when the grease reaches the full length of the pin. Dirt, road salt and water push the grease out of the joint over time, so the pin can run dry even when the outlets look full. A regular routine keeps the pin and bushing moving freely and reduces the wear that loosens the spring end.
Grease the pins after the kit is assembled and again at regular service points. Wipe the fittings clean first so grit does not get pushed into the joint. Inspect the plate and pins for cracks, bends or heavy play, and keep a note of how often the pins need greasing in your conditions. Early attention is much cheaper than a worn pin that has damaged the plate.
- Wipe fittings before greasing
- Watch for grease that comes out dark or gritty
- Check plates after rough trail runs
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | OMEGS15 |
| UPC | 9332018009791 |
| Product type | Leaf spring shackle and pin kit |
| Position | Rear |
| Lubrication | Greasable, two grease outlet holes per pin |
| Assembly | Bolt-together |
Vehicle fitment
It is a direct fit for the 2005–2014 Nissan Xterra in Off-Road, PRO-4X, S, SE and X trims.
Coverage is limited to the 2005–2014 Xterra, so other Nissan models are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Grease each pin through its two outlet holes after assembly. Support the frame and axle on jack stands before removing the old shackles, since the rear spring is under load.
What’s included
Compare the parts in your kit with your installation before starting work.





