Overview
The Trail Gear 140064-1-KIT Creeper Axle Ball Gussets reinforce the knuckle ball on a solid Toyota front axle. They guard against bending at the outer knuckle ends, where large tires and rough driving put stress.
The upper gussets have holes for shock mounts, so the kit covers shock mounting as well as knuckle reinforcement. It fits the 1984-1985 Toyota 4Runner and 1979-1985 Toyota Pickup models.
Key features
- Reinforces the knuckle ball against bending
- Upper gussets with shock mount holes
- Two lower gussets
- Eight steering stop gussets
- Unpainted steel finish
Before you weld
Creeper gussets bridge the knuckle ball and the axle, so the load from big tires and hard landings moves through the gusset rather than the knuckle end. Good weld preparation matters more than anything else here. Clean the mating surfaces down to bare metal, fit each gusset squarely against the knuckle before tacking, and work in short passes so the heat does not distort the axle. Grinding the weld toes smooth reduces stress risers that would otherwise crack under repeated flex.
Because this kit is unpainted, bare steel will start to rust quickly once it sees water and road salt. Prime and paint after the welds cool and the grinding is finished. Inspect the welds and gussets after the first few trail outings and again at each oil change, and look for hairline cracks at the gusset edges and the knuckle ball.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140064-1-KIT |
| UPC | 70000621714 |
| Axle ball gussets | 2, with shock mounts |
| Lower gussets | 2 |
| Steering stop gussets | 8 |
| Finish | Unpainted |
| Fitment type | Direct fit |
Vehicle fitment
The kit fits the 1979-1985 solid Toyota front axle. Covered models are the 1984-1985 Toyota 4Runner (DLX, SR5) and the 1979-1985 Toyota Pickup (Base, DLX, DLX Turbo, SR5, SR5 Turbo). Confirm your vehicle’s year, model and trim before ordering.
Trims not named in the list are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding and grinding are required for installation. Because the finish is unpainted, plan to protect the steel after the welds are complete.
What’s included
Two axle ball gussets with shock mounts, two lower gussets and eight steering stop gussets.









