Overview
The TeraFlex 4116250 is a large angled rod end, a forged finished joint with a 10 degree angle off the joint. The angle gives extra clearance for tires or other frame configurations.
TeraFlex uses this forging on its JK lower control arms, where the angle improves tire clearance in tight turns. The flex ends provide articulation and durability and dampen road noise and vibration.
Key features
- 10 degree angle off the joint for added tire clearance
- Forged finished joint with flex ends for articulation
- Dampens road noise and vibration, per the manufacturer
- Serviceable joint with right hand thread
Articulation and arm geometry
A rod end is the joint that lets a control arm pivot as the axle moves, so the joint must allow movement in several directions at once. Angled ends change the position of the joint relative to the arm, which can alter how the arm travels and how much tire clearance remains at full turn. Any change of angle should be checked against the arm’s travel and nearby parts such as the frame and brake lines.
Check the joint for play after installation and at each service interval. Look for torn seals, cracks in the forging, and slop in the joint when the arm is loaded. Replace the joint if it binds, feels rough, or shows heavy movement, since a worn rod end can change the alignment of the axle.
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 4116250 |
| UPC | 843885025757 |
| Joint details | Finished joint |
| Type | Forged |
| Maintenance | Serviceable |
| Thread | 1-1/4 x 12 UNF, right hand |
| Center bolt diameter | 9/16 inch [14mm] |
| Shoulder width | 2-5/8 inch |
| Angle off joint | 10 degrees |
| Jam nut wrench size | 1-7/8 inch |
| Fitment | Universal fit |
Vehicle fitment
It is universal fit and is used on TeraFlex JK lower control arms, so match its thread and bolt size to your arm.
No Wrangler generation, year range or other model is named for this rod end. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set the jam nut with a 1-7/8 inch wrench and keep the 1-1/4 x 12 right hand thread matched to the arm. Check that the joint is fully threaded and the jam nut is tight before the arm carries load.
What’s included
Check the package contents against your installation before starting, including whether a jam nut or bolt is needed.







