Overview
The TeraFlex HD Forged Front Flip Draglink, part number 1600448, is a forged front draglink for lifted Jeep Wrangler JK vehicles from 2007–2015. It is designed to address front end shimmy and alignment issues on lifted JKs by flipping the draglink over the knuckle.
The draglink mounts through a new tapered insert and threads into the factory adjusting sleeve, so the factory adjuster setup carries over. It is 50% stronger than the factory draglink and is aimed at lifted JK setups, including 4 inch lift kits.
Key features
- Forged HD draglink that flips over the knuckle
- New tapered insert for mounting into the knuckle
- TeraFlex states 50% more strength than the factory draglink
- Helps address front end shimmy and alignment issues on lifted JKs
- Threads into the factory adjusting sleeve
- It is a direct bolt-on fit for lifted JKs.
Steering wear and the flipped link
The draglink carries the force between the steering box and the knuckles, so wear shows up as play, shimmy and a loose feel at the wheel. Flipping the link over the knuckle changes the angle it runs at, and that is the reason a flipped design is often paired with a steering stabilizer and an alignment check. Stock adjusting sleeves can wear too, so inspect them when the link is out.
Watch for loose joints, torn boots, and bent tubing after rough trail use. Grease the ends if the design calls for it and re-check the threaded fit at the adjusting sleeve after the first drive. Alignment should be checked after any draglink change, because the toe setting can shift once the linkage is under load.
- Look for loose joints and torn boots
- Re-check the sleeve threads after the first drive
- Align the front end after any linkage change
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1600448 |
| UPC | 843885022503 |
| Construction | Forged HD draglink |
| Mounting | Flipped over the knuckle with tapered insert |
| Strength | 50% stronger than factory draglink (TeraFlex claim) |
| Adjustment | Threads into factory adjusting sleeve |
| Installation type | Direct bolt-on |
Vehicle fitment
The manufacturer fitment list covers the 2007–2015 Jeep Wrangler (JK), with trims including 70th Anniversary, Rubicon, Sahara, Sport and X, plus Unlimited versions of several of them.
Years after the listed range and other Wrangler generations such as TJ, LJ and JL are not covered by this list. Match your model year and trim to the list entries before choosing this part.
Installation notes
The draglink threads into the factory adjusting sleeve, so the existing sleeve is reused rather than replaced. Because steering linkage is involved, have front alignment checked once the draglink is installed on a lifted JK.
What’s included
The kit is the draglink itself. Check the package contents against your installation before starting.









