Overview
The Ten Factory GM 8.875-inch 12 bolt replacement rear axle (part number MIDMG27133) is a direct replacement for the original rear axle shaft on a GM 12 bolt 8.875-inch axle. It has 30 splines and fits the driver or passenger side.
The shaft is a direct replacement that needs no modifications, so the existing axle hardware is reused when fitting it. It is made from High Manganese 1541H material, which takes a deeper and harder heat treatment than typical original equipment shafts.
Key features
- Direct replacement for the original shaft, without modifications
- High Manganese 1541H material
- Deeper, harder heat treatment from the High Manganese 1541H material
- 30 splines, driver or passenger side
Choosing a replacement axle shaft
A rear axle shaft carries engine torque from the differential to the wheel hub, so it takes the full load of driving and braking. On a GM 12 bolt, the spline count has to match the differential side gear exactly, or the shaft will not engage. Before buying, confirm the axle type, the shaft position and the spline count rather than relying on axle size alone.
Shafts usually wear at the splines, the bearing journal and the flange where the bolts pass through. Inspect for twisting, cracks, scored bearing surfaces and loose or stretched studs, especially after hard off-road use where sudden load changes stress the shaft. Replacing a shaft often means checking the axle bearing and seal at the same time, since they come out during the same job.
- Match the spline count to the differential side gear
- Inspect the axle bearing and seal while the shaft is out
- Replace worn axle studs and nuts with the shaft
Specifications
| Brand | Ten Factory |
|---|---|
| Part number | MIDMG27133 |
| Axle type | GM 12 bolt 8.875 inches |
| Axle location | Rear |
| Shaft position | Driver or passenger side |
| Spline count | 30 splines |
| Material | High Manganese 1541H |
| Warranty | Ten-year replacement warranty (Ten Factory) |
Vehicle fitment
It is a universal fit for the GM 12 bolt 8.875-inch rear axle. Match the axle type and spline count to your axle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shafts are direct replacements that need no modifications, so the existing axle hardware is used when fitting them.








