Overview
The Smittybilt receiver D-ring mount, part number 29312, is a heavy-duty D-ring that fits into any 2 inch receiver. It gives a rigging point for recovery and towing, and it is rated up to 10,000 lbs of pulling capacity on straight pulls.
The D-ring is zinc coated cast steel and has a 3/4 inch pin. It is a receiver mounted rigging point.
Key features
- Fits any 2 inch receiver
- Rated up to 10,000 lbs on straight pulls
- Zinc coated cast steel
- 3/4 inch pin
Rigging a receiver D-ring
A receiver-mounted D-ring gives a recovery strap or shackle a fixed point at the rear of the vehicle. The hitch and receiver carry the load, so the connection is only as strong as the receiver tube, the pin, and the way the D-ring is seated. Pull straight when possible, since side loads and angled pulls put stress on the mount in ways the straight rating does not cover.
Before a recovery, check that the pin is fully inserted and secured with its clip, and that the D-ring rotates freely without binding. Use a rated shackle or strap with a capacity suited to the load, and avoid stacking hardware in ways that add shock. A slow, steady pull reduces the chance of a sudden load on the mount.
- Seat the pin fully before each pull
- Look for bending or cracks in the cast steel
- Avoid jerking loads
- Store the D-ring clean and dry between uses
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 29312 |
| UPC | 631410082296 |
| Product type | Receiver mounted D-ring |
| Receiver size | 2 inch |
| Pulling capacity | Up to 10,000 lbs on straight pulls |
| Material | Zinc coated cast steel |
| Pin | 3/4 inch |
Vehicle fitment
This mount is not tied to a specific vehicle. It fits any 2 inch receiver, so confirm your vehicle has a 2 inch receiver before buying.
Confirm the receiver size and pulling rating against your recovery setup before ordering.






















