Overview
The Factor 55 HitchLink, part number 00020-01, is a D-ring mount that fits a standard 2-inch receiver hitch and turns it into a recovery point. It is made from 6061-T6 aluminum and weighs 1/3 of conventional steel designs.
Because it fits any standard 2-inch receiver, it is not tied to one vehicle. The receiver hitch’s factory pull rating sets the real limit, so stay under that rating at all times.
Key features
- Precision CNC machined from 6000 series aluminum
- Weighs only 1/3 of conventional steel designs
- Anodized and powder coated for oxidation protection
- Fits standard 2 inch receivers and 3/4 inch screw pin shackles
- Made in USA
Using a D-ring on a hitch
A hitch-mounted D-ring turns the receiver into a short, fixed recovery point, which makes the load path easy to see but also easy to misjudge. The pull goes through the hitch pin, the receiver tube, and the vehicle frame, so each part has to be sound. Angled pulls put side load on the shackle and the pin, which is why a straight line from the hitch is the safest approach. Aluminum mounts stay light on the bumper, but they still need the same respect for rated load as steel.
Before each use, look over the coating for chips, check the shackle pin for wear, and make sure the hitch pin sits fully seated. A hitch that has been bent, cracked, or loosened in its receiver should be repaired before any recovery. Keep the shackle hand tight and clear of the strap path, and expect the mount to warm under a long pull. Good gear care keeps this simple setup reliable through many trail seasons.
- Inspect the coating for chips after each trip
- Seat the hitch pin fully before pulling
- Keep the pull in line with the receiver
Specifications
| Brand | Factor 55 |
|---|---|
| Part number | 00020-01 |
| UPC | 700006384066 |
| Material | 6061-T6 aluminum, 6000 series |
| Finish | Red, anodized and powder coated |
| Receiver size | Standard 2 inch |
| Shackle fit | Standard 3/4 inch screw pin shackles |
| Rated load | 9500 pounds |
| Ultimate failure | 51,000 pounds |
| Weight compared with steel | 1/3 of conventional steel designs |
Vehicle fitment
It is not sized to a specific vehicle. It fits standard 2-inch receivers, so fit depends on the receiver hitch on your vehicle rather than the model.
Check your receiver’s factory pull rating before using the HitchLink. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Secure the mount with a quality steel alloy 5/8 hitch pin. Pull in line with the hitch and do not bind or side load the shackle. Never exceed the factory receiver hitch pull rating.
What’s included
Check the included hardware against your installation before starting.
Not included: a quality steel alloy 5/8 hitch pin, which is needed to secure the mount.


















