Overview
The Smittybilt XRC front bumper 76806 is a one-piece welded front bumper made from 3/16 inch cold rolled steel, with a built-in winch plate and a two stage textured matte black powder coat. The XRC design offers high approach angles and raised corners for ground clearance.
The bumper is robotically welded, and the welds are ground down and smoothed before coating. Solid mount D-rings are welded on the inside and outside. The front stinger is 1.75 inch tubing with two light tabs that hold up to two 9 inch lights. The winch plate can carry a winch up to 10,000 lb, with an aluminum or roller fairlead. A 5 year limited warranty applies.
Key features
- Robotically welded one-piece design from 3/16″ cold rolled steel
- Built-in winch plate for a winch up to 10,000 lb, with aluminum or roller fairlead
- Raised corners for entry and exit angles
- Solid mount D-rings welded on the inside and outside
- Stinger from 1.75″ tubing with two light tabs for up to two 9″ lights
- Solid plate center section wraps the frame horns and lower crossmember
- 1.75″ over rider and kickers
- Two stage textured matte black powder coat
Mounting a winch on the bumper
A winch plate on a front bumper carries the load of a recovery, so the mounting points and the frame behind them matter as much as the bumper itself. Before adding a winch, check that the winch’s rated pull and mounting bolt pattern fit the plate, and choose the fairlead type that suits your line. Roller fairleads reduce line wear on rough pulls, while aluminum fairleads are a common lighter choice for lighter use.
After the first few trail runs, look over the welds, the D-ring mounts and the bumper bolts. Re-torque fasteners and touch up any chipped powder coat before rust starts at bare spots. Keep a winch strap or soft shackle handy, and avoid hooking a line to a single point on the bumper when a wider anchor is available.
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 76806 |
| UPC | 631410109467 |
| Type | XRC front bumper |
| Material | Cold rolled steel, 3/16″ |
| Finish | Two stage textured matte black powder coat |
| Maximum winch | 10,000 lb |
| Fairlead options | Aluminum or roller |
| Stinger tubing | 1.75″ |
| Light tabs | Two, for up to two 9″ lights |
| Warranty | 5 year limited |
Vehicle fitment
Fit depends on the vehicle’s year, model and chassis code, so match those details before buying.
Confirm fit for your vehicle’s year, model and trim before ordering, and check the mounting points against your frame before installing.
Installation notes
Minor drilling is needed to finish the installation. A winch and fairlead are added separately.
What’s included
- XRC front bumper with built-in winch plate
- Solid mount D-ring mounts
- Stinger with two light tabs
Not included: the winch, fairlead and lights.






















