Overview
The Smittybilt D1098CC-SS is a polished stainless nerf step set for the Dodge Ram 2500 and 3500 heavy-duty pickups. It fits the 2010 Ram 2500 in Laramie, Power Wagon, SLT, ST, SXT and TRX versions, the 2010 Ram 3500 in Laramie, SLT and ST versions, and the 2011 to 2016 Ram 2500 and 3500 in the trims covered for each year range.
Each step is a four- or six-step drop-down design on a 3-inch main tube. Cleated step plates provide firm footing, and the steps carry loads of up to 445 pounds. The design suits lifted heavy-duty trucks, where the higher step makes entry easier on tall cabs.
The steps are a one-piece unit that bolts to the frame, so the brackets do not need to be assembled before fitting. The stainless finish is the same on both sides, and the steps are sold for wheel-to-wheel coverage on the listed trucks.
Key features
- Polished stainless steel finish
- Wheel-to-wheel length
- Four or six step drop-down design
- Three-inch main tube
- Cleated step plates
- Rated for up to 445 pounds
- One-piece bolt-on frame mount
- Helps protect rocker panels
Choosing a lift height
Side steps on a lifted heavy-duty truck do most of their work at the cab door, where ride height can make the gap between the ground and the door sill hard to reach. A drop-down step closes that gap and lets passengers and crew get in and out without climbing. Measure your current ride height and running board height before deciding how far the step should drop, since a step that sits too low can catch on rough ground.
Think about how the truck is used. Daily driving on pavement puts little strain on the steps, while job sites and trail use bring mud, rocks and side impacts. Check tire clearance at full suspension travel and confirm the frame mounts are clean and solid before fitting. Keep the step area clear of heavy loads that could bend the plates.
- Measure ride height before choosing the drop
- Check tire clearance at full suspension travel
- Clean frame contact points before bolting up
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | D1098CC-SS |
| Finish | Polished stainless steel |
| Length | Wheel to wheel |
| Main tube | 3 inches |
| Step design | Four or six step drop-down with cleated plates |
| Load rating | Up to 445 pounds |
| Installation | One-piece unit bolts to frame |
Vehicle fitment
It fits the 2010 Dodge Ram 2500 and 3500, and the 2011 to 2016 Ram 2500 and 3500, in the trims covered for each year range. Confirm your vehicle’s year, model and trim before ordering.
The Ram 1500 and the 2017 and later heavy-duty Ram trucks are not covered by this fitment. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The kit includes one nerf step unit, with no bracket assembly needed. Verify the parts you received against your installation plan before starting.









