Overview
The Smittybilt Sure Step 3″ Diameter Side Bars in stainless steel, part number S/BJN460-S2S (model JN460-S2S), are wheel-to-wheel side steps for the 1997–2006 Jeep Wrangler (TJ). Side bars, also called nerf bars or side steps, give a place to step when getting into the Jeep.
The Sure Step design has non-slip polyester step pads secured with 5 pins, no exposed metal to rust, and a rugged eight-point frame mount. The bars use a 3-inch diameter tube, a stainless steel finish and a dense zinc undercoating, and install without drilling.
Key features
- 3″ diameter tube in a stainless steel finish
- Dense zinc undercoating
- No-drill installation
- Rugged eight-point frame mount for strength and rigidity
- Heavy-duty welded design
- Non-slip polyester step pads secured with 5 pins in a squashed step
- Oversize bolt attachment, which Smittybilt says prevents tube step bounce
- All installation hardware included; supplied as a pair
Before you install side steps
Side bars are for stepping up into a Wrangler, but they also protect the rocker area from brush and rock contact. Because the bars sit low, their height and mounting position affect how easily you can climb in, and they should not reduce ground clearance more than your trail use allows.
Side steps take repeated weight from people climbing in and out, so the frame mounts carry the loads over time. After installation, inspect each mount bolt, the welds and the step pads for wear. Pads that loosen or crack should be replaced, and bolts should be rechecked whenever the bars come off for other work.
Stainless tubes resist corrosion, but any scratched or chipped coating on the mounting brackets can still rust. Clean road salt and mud from the frame area regularly, and keep the pads free of grit so they grip well in wet weather. Pairing the steps with a rear bumper or fender flare may change clearance, so check that the bars still clear your tires at full steering lock.
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | S/BJN460-S2S |
| Product type | Side bars (side steps) |
| Tube diameter | 3″ |
| Length | Wheel to wheel |
| Finish | Stainless steel |
| Undercoating | Dense zinc |
| Step pads | Non-slip polyester |
| Mounting | Eight-point frame mount, no drilling |
| Quantity | Pair |
| Fit type | Direct fit |
Vehicle fitment
The bars fit the 1997–2006 Jeep Wrangler (TJ) in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
The bars run wheel to wheel, between the front and rear wheel openings. Measure the wheel openings on your vehicle to confirm fit before installing.
These side bars are for the Wrangler TJ only, not the YJ, LJ, JK or JL.
Installation notes
Work through the package steps and tighten each fastener to the torque values given there. Retighten the hardware after the first drive and again after heavy trail use. A qualified shop can handle the installation if the work feels beyond you.
Side steps are loaded by people stepping on them, so after installation check that every frame mount bolt is tight, that the bars are level and firmly attached, and re-check them after the first miles of driving.
What’s included
A pair of side bars with all installation hardware.











