Overview
The Smittybilt JN44-S2B is a black powder coat side bar sold as a pair, built for the 1987–1995 Jeep Wrangler (YJ). It fits the Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport versions of that generation, and it runs wheel to wheel.
The 3-inch tube is welded and heavy duty. An eight-point frame mount holds the bar firmly, which keeps the tube from bouncing under load. The step pads are non-slip polyester, held by five pins in a squashed step.
Smittybilt describes most installs as no-drill, and the hardware needed for the mount is included with the pair.
Key features
- Black powder coat finish
- Three-inch tube
- Eight-point frame mount
- Heavy-duty welded design
- Non-slip polyester step pads with five pins
- No-drill installation on most applications
- Sold as a pair with hardware included
Frame mounts and wheel-to-wheel bars
A wheel-to-wheel side bar on an older Wrangler is mostly used as an entry step and a guard for the rocker area. The YJ body is narrow and sits fairly close to the ground, so a bar mounted to the frame keeps the step out of the way of the doors while leaving room for the tires to move.
Frame-mounted designs put the load on the chassis rather than the body panels. That matters for YJ owners who run larger tires or a suspension lift, because added height changes the angle of the step and the stress on the bracket. Check the frame under the mount for rust, and make sure the mounting points are still flat and solid before bolting the bar in.
Routine care is straightforward. Rinse mud and salt off the tube and pads, look for chips in the black powder coat, and re-tighten the bolts after the first few trips. Replacing worn pads and any cracked pins keeps the step secure for passengers climbing in and out.
- Inspect frame rails under the mount for rust
- Check the bar’s clearance after a suspension lift
- Re-tighten frame bolts after the first few trips
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | JN44-S2B |
| Finish | Black powder coat |
| Tube diameter | 3 inches |
| Length | Wheel to wheel |
| Mount | Eight-point frame mount |
| Step pads | Non-slip polyester, secured with five pins |
| Quantity | Sold as a pair |
Vehicle fitment
The side bar fits the 1987–1995 Jeep Wrangler (YJ) in its Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport versions. Later Wrangler generations, including the 1997–2006 TJ, are outside this fit. Confirm your vehicle’s year, model and trim before ordering.
Later Wrangler generations, including the 1997–2006 TJ, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
A pair of side bars with step pads and all installation hardware.











