Overview
The Smittybilt M1 Toyota FJ Rear Bumper, part number 614840, is a black rear bumper with D-ring mounts, a receiver hitch and additional rear lights included.
Smittybilt says each M1 is made from 3/16″ cold rolled steel with 1/4″ mounting plates and finished in its signature two stage matte black powder coat. Each M1 comes standard with 7/8 inch solid D-ring mounts, which are welded on the inside and out, and bolts on completely without drilling.
Smittybilt backs the bumper with a 5 year limited warranty and also lists its Advantage Warranty, a limited lifetime warranty.
Key features
- Two stage matte black powder coat
- 3/16″ and 1/4″ cold rolled steel construction
- Solid mount D-rings welded on the inside and out
- Bolts on without drilling
- Additional rear lights included
- 5 year limited warranty
Rear bumper buyer’s notes
A rear bumper often carries the hitch, the lights and the recovery mounts, so it takes more load than a factory bumper. The D-ring mounts are the main recovery points, and they work best when the bumper frame is tied to the truck’s structure. Before a trail trip, inspect the welds around the mounts and the bolts holding the bumper to the body.
A receiver hitch changes how the truck tows and what it can carry. Match hitch use to the rating of the hitch and the vehicle, and do not let added accessories push total weight beyond what the truck is built for. Rear lights need a clean wiring route and a solid ground, so check the harness for chafing after the first few drives.
- Check the powder coat for chips and touch them up
- Re-tighten mounting bolts after rough trail use
- Keep the light connectors sealed against water and mud
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 614840 |
| UPC | 631410102734 |
| Series | M1 |
| Material | 3/16″ cold rolled steel with 1/4″ mounting plates |
| Finish | Two stage matte black powder coat |
| D-ring mounts | 7/8 inch solid |
| Receiver hitch | Yes |
| Tire carrier | No |
| Rear lights | Additional lights included |
| Warranty | 5 year limited; Advantage Warranty limited lifetime |
Vehicle fitment
The bumper is for the Toyota FJ. Confirm that your truck’s model year matches before ordering, and check the trim against the fitment before you buy.
The part number is for the FJ; other Toyota trucks use a different M1 bumper. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The M1 bolts on completely and needs no drilling.
What’s included
- M1 rear bumper
- 7/8 inch solid D-ring mounts
- Additional rear lights




















