Overview
The Smittybilt Tubular Jeep Rear Bumper in stainless steel, part number S/BJB48-RHS, is a one-piece rear bumper for the 2007–2018 Jeep Wrangler (JK), in 2-door and Unlimited 4-door models. It includes a receiver hitch with a 2000 lb towing weight. D-ring mounts are not included.
The bumper is made from stainless steel in a one-piece design with pre-cut vertical uprights. It is robotically welded for durability on the road or off. Tubular Jeep bumpers are offered for the front and rear, and this part is the rear version.
Key features
- One-piece stainless steel tubular design
- Receiver hitch with a 2000 lb towing weight
- Pre-cut vertical uprights for a signature look
- Robotically welded for extreme durability
- Rear design for the JK Wrangler
Installing a rear bumper
A rear bumper carries more weight than most body parts, so the mounting points matter as much as the bumper itself. Before fitting, check the frame mounts and bolt holes for rust or cracks, and make sure the tire and jack area behind the bumper is clear. Because the bumper is built around a receiver hitch, the hitch is the part that will see the most load when towing. Keep trailer loads within the rating and use a hitch pin and clip every time you tow.
Stainless steel resists rust well, but it can still pick up scratches and road grime that trap moisture on the welds. Rinse the bumper after trips through mud or salt and check the welds and mounting hardware each season. Torque the bolts to the specification in your vehicle’s service manual, and re-check them after the first few drives, since new brackets can settle.
- Check frame mounts for rust before installing
- Keep the receiver free of mud so the hitch pin still slides in
- Re-check bolts after the first drives
- Inspect the welds for hairline cracks after rough trails
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | S/BJB48-RHS |
| Position | Rear |
| Finish | Stainless steel |
| Receiver hitch | Included, 2000 lb towing weight |
| D-ring mounts | Not included |
| Tire carrier | Not included |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK) in 2-door and Unlimited 4-door models.
The list does not include the Wrangler JL, TJ or LJ, the Gladiator, or any model year before 2007 or after 2018. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The one-piece stainless steel rear bumper with its receiver hitch.
Not included: D-ring mounts and a tire carrier are not included.









