Overview
The Smittybilt M1 Front Bumper in black, part number 612821, is a full-width steel truck front bumper with a built-in winch plate, 7/8 inch solid D-ring mounts and driving and fog lights. Smittybilt makes it from 3/16 inch cold rolled steel with 1/4 inch mounting plates, finished in a two-stage powder coat.
The center section is a solid plate that wraps the frame horns and the lower cross member. The winch mount system holds a winch up to 16,500 lb. The bumper bolts on without drilling.
Key features
- 3/16 inch cold rolled steel with 1/4 inch mounting plates
- Solid plate center section wraps the frame horns and lower cross member
- Built-in winch plate that holds a winch up to 16,500 lb
- 7/8 inch solid D-ring mounts with welds on the inside and out
- Ultra Bright driving and fog lights included
- Two-stage powder coat in black
- Bolt-on installation that needs no drilling
Winch Setup and Bumper Weight
A full-width steel bumper adds considerable weight to the front of a truck, which changes steering feel, braking and suspension load. Before adding a winch, check that the truck’s front suspension, springs and tires are rated for the extra mass. A winch rated near the bumper’s limit should be mounted with the proper hardware and used with a rated synthetic or steel line, and the winch’s control wiring should be routed away from heat and sharp edges.
Steel bumpers can trap moisture where the plates meet the frame. Check the mounting plates and the winch mount area for rust after wet trips, and touch up any bare spots before they spread. Re-check the bolts after the first few trail runs, since a winch under load pulls on the bumper and the frame.
- Match the winch mounting bolts to the plate hardware
- Confirm the truck’s suspension and tires handle the added weight
- Inspect winch cable and hook before each recovery
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 612821 |
| UPC | 631410115512 |
| Product type | Front bumper, M1 series |
| Position | Front |
| Width | Full |
| Material | Steel, 3/16 inch with 1/4 inch mounting plates |
| Finish | Two-stage powder coat, black |
| Winch capacity | Up to 16,500 lb |
| D-ring mounts | 7/8 inch solid D-rings, included |
| Light mounts | Included |
| Winch mount | Included |
| Fit type | Direct fit |
Vehicle fitment
It is a direct-fit truck bumper. No vehicle is named for this part, so confirm fit for your vehicle’s year, model and trim before ordering.
Confirm fit for your vehicle’s year, model and trim before ordering. Related M1 bumpers for the Ford F-150 and the Toyota Tundra are sold under different part numbers.
Installation notes
The bumper bolts on completely and needs no drilling. The winch mount system takes the winch separately, so plan the winch and its wiring before hanging the bumper.
What’s included
- M1 front bumper in black powder coat
- 7/8 inch solid D-ring mounts
- Ultra Bright driving and fog lights
- Winch mount system
Not included: the winch.









