Overview
The Skyjacker 172EPK is a suspension lift kit listed at a 1.5-2 inch lift. Its contents are front coil springs and rear Add-A-Leafs.
The components are powder coated black. Other parts are needed to form a complete set, so review the full parts needs before ordering.
Key features
- 1.5-2 inch lift
- Front coil springs included
- Rear Add-A-Leafs included
- Powder coated black finish
- Limited lifetime warranty stated by Skyjacker
Alignment and driveline checks
A lift in this range changes the geometry that wheel alignment depends on, so it is worth checking caster and toe once the work is done. Coil springs and Add-A-Leafs alter ride height and load on each axle, and the driveshaft angles move with them. Steep angles can cause vibration, U-joint wear and driveline noise, so measure them rather than guessing.
Shocks and bump stops often need attention with a new lift. Extended shocks may bottom out sooner, and bump stops can start contacting the frame or axle at full compression. Inspect rubber parts and brake hoses for stretch. Tire wear patterns help show whether the setup is aligned correctly, so review them after the first few drives.
- Check caster and toe after the work is done
- Measure driveshaft angles for vibration
- Inspect bump stops and brake hoses for stretch
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | 172EPK |
| UPC | 803696103457 |
| Lift height | 1.5-2 inch |
| Finish | Powder coated black |
| Included | Front coil springs, rear Add-A-Leafs |
| Warranty | Limited lifetime warranty. |
Vehicle fitment
Fit has not been confirmed for any Jeep or truck. Match your vehicle’s year, model and trim before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
After a lift of this range, expect to recheck wheel alignment and driveline angles. The kit needs other parts to form a complete set, so read the full requirements before starting.
What’s included
Front coil springs and rear Add-A-Leafs.
Not included: Parts beyond the kit are needed to complete the set. Review the full requirements and check the package contents before starting.







