Overview
The Skyjacker 2 Inch Suspension Lift Kit with Front Aluminum Spacers, part number FB2120MSPB, is a 2 inch lift for the 2021–2026 Ford Bronco. It fits the Bronco in the Badlands, First Edition and Wildtrak trims on models equipped with the Sasquatch Package and Bilstein struts. It does not fit the Bronco Sport.
The kit keeps the factory performance struts and uses strut spacers to raise the stance. The Bronco’s independent front suspension and five-link rear are both stabilized with struts at all four corners, so the spacers work with the existing struts and control arms.
The factory independent front suspension stays in place, and the shorter top mount spacer keeps the upper control arm from binding against the strut. Check the CV axle angles after fitting, because the axles must stay within the limits set by the factory control arms.
Key features
- Two-piece front aluminum strut spacers
- Factory performance struts retained
- Rear block and spacer lift
- Clearance for up to 37 inch tires
- Front spacers CNC machined from 6061-T6 aluminum
Why spacers suit Bronco
Strut spacers keep the factory struts in service while raising the front, which is a different approach from a full strut replacement. The Bronco’s independent front suspension depends on the upper control arm and strut moving freely, so the short top mount spacer is what keeps the control arm from binding. Because the struts stay in place, their wear and condition matter more than they would in a swap.
Before fitting, check the factory struts, bushings and bump stops for wear, since they will carry the new height. CV axle angles deserve close attention because the axles must stay within the limits set by the control arms. Alignment is normally needed after front height changes, and tires should be checked for clearance at full steering lock.
- Inspect the factory struts before fitting
- Check CV axle angles after the first drives
- Set alignment once the height has settled
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | FB2120MSPB |
| Lift | 2 inch |
| Lift height range | 0 to 3.5 inches |
| Front spacer material | 6061-T6 aluminum |
| Rear lift method | Block and spacer |
| Front shocks | Reuse OEM |
| Rear shocks | Reuse OEM |
| Shocks included | No |
| Tire size (listed) | 35 inch |
Vehicle fitment
It fits the 2021–2026 Ford Bronco in the Badlands, First Edition and Wildtrak trims, on models with Bilstein struts and the Sasquatch Package.
The kit does not fit the Bronco Sport. Bronco years outside 2021–2026 and Bronco trims not named here are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The short top mount strut spacer keeps the factory upper control arm from binding against the strut, and the two front spacers add the height in sequence. The CV axles operate within the limits set by the factory control arms, so check the axle angles after fitting.
What’s included
Front aluminum strut spacers and a rear block and spacer. Shocks are not included, and the factory struts are reused.








