Overview
The Rugged Ridge A-Pillar 4 Switch Pod Kit (part number 17235.59) is a pillar-mounted switch pod for the driver’s side A-pillar. Premolded cutouts hold up to four aftermarket switches in easy reach and out of the way of the shifter handle.
The pod is made for both left-hand drive (LHD) and right-hand drive (RHD) Jeeps. Its textured molded finish matches the factory plastic pillar cover it replaces, and it snaps into place the way the original cover does. Match your vehicle’s year, model and trim to the fitment before ordering.
Key features
- Premolded cutouts for up to four aftermarket switches
- Driver’s side A-pillar mount
- Available for LHD and RHD Jeeps
- Textured molded finish like the factory pillar cover
- Snaps into place like the OE part
Choosing and wiring switches
Pillar pods sit in the driver’s line of sight, so the layout should put the switches you use most within easy reach without blocking the view of the gauges or the road. Place the heaviest-use switches at the front of the cutouts and keep less-used controls toward the outside edge. Check the viewing angle from the driver’s seat before anything is fixed in place, then mark the positions with the pod held in position.
Switch choice affects the wiring more than the pod does. Momentary and latching switches behave differently, and lighted switches need a ground in addition to the power feed. Each circuit should have its own fuse, and the harness should be tied off away from the airbag and steering column area. Good strain relief at each connector keeps vibration from pulling wires loose on rough trails.
- Check each switch’s current rating against its load
- Route wiring away from steering column components
- Test every circuit before the trim is fully secured
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 17235.59 |
| UPC | 804314237516 |
| Switch capacity | Up to four aftermarket switches |
| Steering configuration | LHD and RHD Jeeps |
| Mounting location | Driver’s side A-pillar |
| Finish | Textured molded |
Vehicle fitment
It is made for both LHD and RHD Jeeps, which covers either steering configuration. Verify fit by year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The pod is a snap-in part with no drilling or cutting. Plan the wiring for each switch you add before installing the pod.
What’s included
The kit includes the A-pillar switch pod. Plan on supplying your own switches.









