Overview
The Rugged Ridge Etched A-Pillar 4 Switch Pod Kit, part number 17235.71, puts a switch pod on the driver’s side A-pillar and comes with five 2-position etched rocker switches. Rugged Ridge gives the switch labels as Zombie Lights, Light Bar Lights, Sasquatch Lights, Rock Lights and Off-Road Lights.
The pod has a textured finish that matches the factory pillar cover, and it installs by snapping into the same position. Its premolded cutouts hold up to four aftermarket switches, placed out of the way of the shifter handle.
Key features
- Five 2-position etched rocker switches in the kit
- Premolded cutouts for up to four aftermarket switches
- Driver’s side A-pillar placement
- Textured molded finish that matches the factory cover
- Labels include Sasquatch Lights and Off-Road Lights
Lighting controls in the pillar
Pillar-mounted switches are used mostly for lights, since the driver can reach them without looking down. A light bar, rock lights or a work light each need a switch that can take the load, so check the rating of the wiring before running it. Keep switch cables short and neat so they do not catch on the door frame.
Harness routing is where most problems start. Run the wiring along the existing trim, keep it clear of airbag components and moving parts, and secure every run with clips. Test each circuit with the engine running before the trim goes back on.
- Confirm the wire gauge suits each load
- Keep harnesses clear of the door frame
- Test circuits before closing the trim
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 17235.71 |
| UPC | 804314297381 |
| Switch count | Five 2-position etched rocker switches |
| Pod capacity | Up to four aftermarket switches |
| Mounting location | Driver’s side A-pillar |
| Finish | Textured molded |
Vehicle fitment
It is a direct fit on the driver’s side A-pillar. Check your Jeep’s year, model and trim before you commit to this kit.
Match the model years and chassis codes to your vehicle before ordering, then confirm your year, model and trim.
Installation notes
The pod snaps into place with no cutting. Power each rocker switch through a fused circuit sized for the lights it controls, and finish the wiring before you snap the pod into place.
What’s included
The kit contains the driver’s side A-pillar switch pod and five 2-position etched rocker switches.












