Overview
The Daystar A-Pillar Switch Pod KJ71044BK is a black switch pod that replaces the factory A-pillar and holds four illuminated rocker switches for electrical accessories on a Jeep. The A-pillar is the roof support beside the windshield. Because the pod is a direct replacement, installation is a simple remove-and-replace operation.
Each of the four included rocker switches is a 20 AMP, three-pole switch that lights in red, green, blue or amber. The air pressure gauge and power distribution module are not part of this kit.
Key features
- Direct replacement for the factory A-pillar
- Four rocker switches included
- Rocker switches rated 20 AMP, three-pole
- Illumination in red, green, blue or amber
- Black finish
Wiring the switch bank
A switch pod sits where you can reach it while driving, so plan the switch layout before mounting. Position the switches you use most where your hand falls naturally, and leave room around the pod for wires to exit cleanly behind the trim.
Each rocker switch needs its own fused feed sized to the accessory it runs, along with a ground bolted to clean bare metal. Loose grounds are a frequent cause of flickering lights and switches that do not hold. Route wires away from sharp edges and moving parts, and secure them with clips so they do not rattle.
- Label each switch with the accessory it controls
- Check fuse ratings against accessory draw before wiring
- Keep harness connectors out of standing water
Specifications
| Brand | Daystar |
|---|---|
| Part number | KJ71044BK |
| UPC | 618089004415 |
| Switches included | 4 rocker switches |
| Switch rating | 20 AMP |
| Switch type | 3 pole |
| Illumination | Red, green, blue, amber |
| Color | Black |
| Mounting | A-pillar, direct fit |
Vehicle fitment
It replaces the factory A-pillar on a Jeep as a direct replacement, so fit depends on the exact vehicle.
Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The pod is a remove-and-replace fit for the factory A-pillar. Wire each switch you use through a fused circuit sized to the 20 AMP rating of the switch.
What’s included
The A-pillar switch pod and four rocker switches.
Not included: the air pressure gauge and the power distribution module.












